Help - I have an oil question 2013 Can Am Spyder RT
I recently purchased a used 2013 Can Am Spyder RT from of all places, a Harley Dealership. It only had 5500 miles on it and it was a great deal. I just thought about checking the oil and realize that it's barely showing at the bottom of the dipstick. (Stupid, I know) I need to drive 30 miles to the nearest Can Am dealership to have them change the oil and check it out. Can I drive it that far without adding oil without damaging the engine? If I should at least add a little oil, I really don't have an idea of what kind of oil the prior owner had in there. What oil should I add that won't cause a mixing problem if I don't add the same kind that is currently in it? Unfortunately, I've put several hundred miles on this bike since I bought it. I know it's not leaking because I have it parked in the garage and there is no oil spot. But last time I drove it, I got a warning, i think it was SS(x) fault, then it went into Limp Home Mode and was running poorly. After reading through lots of messages, I think I could have turned the Can Am off and back on and reset it. But I was afraid to turn it off at the time. Now I'm afraid I've ruined something in the engine. I just want to get it to the dealership so they can change the oil and run some diagnostics So, can I drive it when the oil is that low? And if not, what kind do you guys think I should add. THANKS IN ADVANCE!!!!
I recently purchased a used 2013 Can Am Spyder RT from of all places, a Harley Dealership. It only had 5500 miles on it and it was a great deal. I just thought about checking the oil and realize that it's barely showing at the bottom of the dipstick. (Stupid, I know) I need to drive 30 miles to the nearest Can Am dealership to have them change the oil and check it out. Can I drive it that far without adding oil without damaging the engine? If I should at least add a little oil, I really don't have an idea of what kind of oil the prior owner had in there. What oil should I add that won't cause a mixing problem if I don't add the same kind that is currently in it? Unfortunately, I've put several hundred miles on this bike since I bought it. I know it's not leaking because I have it parked in the garage and there is no oil spot. But last time I drove it, I got a warning, i think it was SS(x) fault, then it went into Limp Home Mode and was running poorly. After reading through lots of messages, I think I could have turned the Can Am off and back on and reset it. But I was afraid to turn it off at the time. Now I'm afraid I've ruined something in the engine. I just want to get it to the dealership so they can change the oil and run some diagnostics So, can I drive it when the oil is that low? And if not, what kind do you guys think I should add. THANKS IN ADVANCE!!!!
Last edited: