Handle bar riser?

[Revalden]

I really, really need to raise my 2015RTS handle bars a couple of inches. Is there anything available? I haven't been successful in my quests.

 

[Peter Aawen]

It's not an easy thing to do on the RT's, & I don't believe there's any 'off the shelf' options, altho I believe there are a couple of Spyders mentioned somewhere here on the Forum by their owners, who did the hard yards & fabbed up something to do the job - they even posted some pics. It'd be a few years back now, & IIRC they had to source some 'correct dia' handlebar tubing to make up stub bars to go in the end of the large OE bar/surrounds so they could fit the risers onto the stubs; and the hand-grip units also had to be transferred off the remnants left when they cut the OE bar & onto a longer replacement that had enough protruding so the top end of the risers could grab onto that! :shocked:

So like I mentioned, it ain't easy, but some have been motivated & talented enough to make something work! Over to you, & good luck! :thumbup:

 

[kdp1308]

I don't know of an off the self riser but I think you can just use a 2" block of aluminum and drill 4 holes in it. You will need longer metric socket head cap screws. Be sure and Loctite them in place. The hardest part would be getting the original bolts out.

 

[ARtraveler]

Tri Axis bars from BRP used to help. Adjustment up and back. Pricey at $1K or so.

 

[JayBros]

Here's the BRP catalog page for the Tri-Axis bars. Yes they are pricey but they give a lot of adjustability. I am very satisfied with mine.https://can-am.brp.com/on-road/shop/spyder-accessories/handlebars/tri-axis-adjustable-handlebar-for-all-spyder-rt-models.html

If you try to insert a thick aluminum block you might run into problems with adequate slack in the wiring for the left and right grip assemblies; I don't know.

 

[Spyderlady14]

I have a spyder 2014 STS any suggestions on where can I get risers

 

[BLUEKNIGHT911]

I have a spyder 2014 STS any suggestions on where can I get risers

Post #2 from Peter is correct, a couple of members here found some " dog bone style " risers ( originally for the GS & RS ) and adapted them for the ST and or RT handlebars ….. doing it wasn't easy, but then $ 800.00 isn't easy to come by these days either ….. good luck … Mike hyea: