Garage door opener for 2020+ RT and RTL

[ollicat]

Hey guys. I was searching YouTube and found a guy in the comments section who recommended this. I just bought one and it is on the way (I don't even own a Spyder yet). This should be just the ticket!

https://www.foxtrot4x4.com/collecti...cts/garage-door-opener?variant=36629147320485

OEM look and now I can open and close my garage door.

 

[IdahoMtnSpyder]

Hey guys. I was searching YouTube and found a guy in the comments section who recommended this. I just bought one and it is on the way (I don't even own a Spyder yet). This should be just the ticket!

I see they have them available with a switch that matches 2019 and earlier. Pretty pricey @ $90 but they sure look good!

 

[Valkrocket]

I wish I saw this post before I installed an on/off rocker switch there. But, then again, my GDO is a Wayne Dalton and is not on the approved list of manufacturers for this remote, so I guess I feel a little better about missing out on this install.
Thank you for the post. :thumbup:

 

[Haze]

Thank You for the post. I like your illustration of an installation.
I too have a Door Opener from a company that is not listed- Sommer.
I bought switch on Amazon and spare opener from the manufacturer.
Wired the opener to the switch and installed on the Spyder. Rather a fun project.

 

[samewok]

I have this opener and really like it

 

[Jdr00ejr]

This is a decent option for someone who wants a simple easy setup.

I'm a tinkerer. I wired my own solution up for less than $10 and my garage door opens when I'm in range and flash my high beams. ;-) I have 2 Spyder and a Victory Vision all wired this way.

 

[Bangorbob]

This is a decent option for someone who wants a simple easy setup.

I'm a tinkerer. I wired my own solution up for less than $10 and my garage door opens when I'm in range and flash my high beams. ;-) I have 2 Spyder and a Victory Vision all wired this way.

Would you be willing to share exactly how and the parts needed? I like this idea.

Thanks, Bob

 

[Jdr00ejr]

Would you be willing to share exactly how and the parts needed? I like this idea.

Thanks, Bob

I'll need to pull the info together. I should have mentioned though the I made 4 of them at a time - which is what allowed it to be about $10 a piece. Some of the items I bought in multiples.

Also - what Spyder are you riding? That will matter.