SpyderAnn01
Active member
I made straps that chris cross over the shoulders and connect together by vinyl quick connectors.
I purchased everything needed at JoAnn fabrics. 6' of nylon web strap, two sets of quick connectors for the nylon strap, and brass eyelets.
I cut the strap into 4 pieces ( 2 long and 2 short) melting the cut ends and put a brass eyelet into one end of each strap. This is for the screw to go through for securing the straps to the Spyder. The two long straps I fastened to the inside of the trunk using the screws that hold the backrest on.
The two short straps were fastened to the rear screws that hold the cover on by the passenger hand grips. Using the nylon quick connectors (one set blue and one set black) I put the male end on the top straps and the female end on the bottom straps with the color across from each other - ie blue on the left top and bottom right - this way I could tell that I was correctly crossing them over my shoulder.
Once the straps are connected I can then pull on the strap ends to tighten them down and you are not going to fall off no matter how deep a sleep your in.
When not in use the upper straps go into the trunk and the bottom straps tuck behind the seat all out of sight. No one knows I have them until I point it out.
I was afraid that you were sleeping and wouldn't see this post!