Flag Holder for a 2013 RTL

[Commander]

I saw a post for the positioning of the flag on the spyder, but where can I get a flag holder for my 2013 rtl? can you put the flag on the existing antenna or do you need a new/different setup? Also I have the covers for my Spyder, full and half, will the covers fit with the flag holder mods?

 

[napper39]

there sold by the venders on the main page.:thumbup:

 

[Ex-Rocket]

:agree: or you could check out Ebay.

 

[Cruzr Joe]

The "license plate mounted flag holder" from Rivco is the only one that i know of that does not interfere with either the full or half cover for the Spyder RT series. :thumbup:


Cruzr Joe

 

[lwrydr]

here is a pic of my flag holders (Rivco)

 

[oldguyinTX]

I too have the Rivco flag holders. A snap to install. However, I do have to remove them when I put my full cover on, which I only use when travelling. I just carry a small wrench in the glove box to take them off and put them back on. Only takes a couple of minutes.

 

[Recon]

You can also try flagsoncars.com for mc flags and brackets. I mounted one on each side of my rear trunk lid on old bike and just ordered new brackets only from them for my new RTS at about $15 for 2 brackets

 

[samewok]

The "license plate mounted flag holder" from Rivco is the only one that i know of that does not interfere with either the full or half cover for the Spyder RT series. :thumbup:


Cruzr Joe

d
Joe is right the one for license plate.

 

[SPECTACUALR SPIDERMAN]

The best flag holder i have seen was a 35 year old blond in a bikini, where can i find one of those for my bike when i ride
in a parade?

 

[Bfromla]

The best flag holder i have seen was a 35 year old blond in a bikini, where can i find one of those for my bike when i ride
in a parade?

No pic?! Yes vendors have good selection have heard of putting flag on antenna but needs clamp yo hold on.

But I think would be too low & close to tires & road grime, (you dont want to fly a dirty flag!) rivco has a single mount some drilling may be required..? Or go with decals. & spyderwraps

 

[Oldmanzues]

I would not use a antenna flag, would probably break antenna, seen it happen a lot with gold Wings. My choice would be the ICSC post right this one. the tall version is out of the way for a full cover and I had mine on for 10,00 miles or so. This mounts on the licence plate holder. I am not sure where RIVCO mounts
Flag tip. Cost the trailing edge with seam sealer from a fabric store, Mine is called Fray-edge. I fly a American and a PGR Flag on ICSC holder most of the time. Oldmanzues

 

[Vossr]

Dont put a Flag on the stock antenna

Take my word for this, its nice for a week or 2... then no flag & no antenna. The antenna is not made to take the stress of the extra drag from even a small flag.

And the Antenna is NOT covered under warranty.