Corbin Seat/Passenger Detection Sensor

[BigLefty]

:dontknow: I just replaced my factory seat (2010 RT) with a Corbin. No instructions were included as to what to do with the receptacle that the factory seat Passenger Detection Sensor wiring plugged into. Any recommendations concerning problems with no longer having the sensor and/or problems with the unused wiring connector would be appreciated.

Thanks

 

[PaladinLV]

http://corbin.com/can-am/install_ca-rt-10-e.pdf

AJ

:dontknow: I just replaced my factory seat (2010 RT) with a Corbin. No instructions were included as to what to do with the receptacle that the factory seat Passenger Detection Sensor wiring plugged into. Any recommendations concerning problems with no longer having the sensor and/or problems with the unused wiring connector would be appreciated.

Thanks

 

[Cruzr Joe]

:dontknow: I just replaced my factory seat (2010 RT) with a Corbin. No instructions were included as to what to do with the receptacle that the factory seat Passenger Detection Sensor wiring plugged into. Any recommendations concerning problems with no longer having the sensor and/or problems with the unused wiring connector would be appreciated.

Thanks

Looks like a reinstall is calling you.


Cruzr Joe

 

[ARtraveler]

The directions say it all. I could not remember for sure, but you take the sensor out of the OEM seat and mount it in the new Corbin. Then its plug and play.

 

[BigLefty]

Thanks to PaladinLV for the link to the instructions and to Cruzr Joe & akspyderman for your comments---sounds simple enough.

BigLefty