Can anyone offer hints/tips for the Missing Belt Guard installation and alignment on an RT 2020+

[Deanno]

I just purchased the Spyderpops Missing Belt Guard from Lamonster. I read the instructions and other posts, and examined the physical aspects of the job. Can anyone offer their first-hand experience of tricks and tips for installation and alignment? Also, because I've also installed the Spyderpops KOTT mesh screens, I'm seeing that the adhesive (3M?) is similar to the Missing Belt Guard application. I was less than impressed with the strength of the adhesive given the positive experiences I've had with other applications of the 3M VHB double sided tape. Is the provided stuff staying stuck? Thanks for any feedback on the tricks and tips as well as the adhesive.

 

[Mikey]

My dealings with the 3M tape are make sure you clean the area very well before applying the tape and make sure its dry before applying it! It should stick hard to whatever you put it to. Push and rub it well.

 

[Deanno]

Thank you, Mikey! I learned today how strong that 3M tape is… I don’t have the guard touching anything, but I did get the front alignment further towards the best than intended.

 

[2dogs]

I installed an aluminum guard with self-tapping metal screws after the plastic guard attached with 3M failed. A lot of punishing vibration goes on down there. And yes, I prepped it clean enough to eat off of before I installed the 3M model. I think mine was produced by Inspector Gadget. https://customspyderworks.com/product/inspector-gadgets-drive-belt-stone-guard-for-spyder-st/ Good luck.

 

[Deanno]

Well, we will see how this one performs. I’m hoping my installation doesn’t lead to an early demise.

 

[Bfromla]

Prep clean with rubbing alcohol & let evaporate dry, apply firm pressure appropriately 3-5 minutes to whatever applying , C-clamp or weigh down if possible. Will stick quite well.