Calling up codes on 08 Spyder

[kmakona]

Lamont did a video on calling up codes on his RT. Can the codes be called up on 08 Spyders? I tried finding something, here on Spyder Lovers, but i don't have a lot of luck finding older posts on certain subjects.

 

[Recluze]

From the shop Maual sec 4 pg 198

Turn the ignition key to ON
Press MODE buton repeatedly to scroll to engine hour on gauge
Start engine and run until Check Engine light illuminates or another fault message is displayed
Press and hold MODE button while pushing 'flash high beam' position rapidly 5 times. A minimum of five flashes in 2 seconds or repeat the process.
Release all buttons
If there are no fault codes the "No Active Fault Codes" will be displayed.

I hope this helps.

 

[kmakona]

From the shop Maual sec 4 pg 198

Turn the ignition key to ON
Press MODE buton repeatedly to scroll to engine hour on gauge
Start engine and run until Check Engine light illuminates or another fault message is displayed
Press and hold MODE button while pushing 'flash high beam' position rapidly 5 times. A minimum of five flashes in 2 seconds or repeat the process.
Release all buttons
If there are no fault codes the "No Active Fault Codes" will be displayed.

I hope this helps.

Mahalo, exactly what i was looking for.

 

[NancysToy]

Remember, these procedures only call up active codes. Stored codes have to be pulled up via BUDS.