BRP Driver Backrest

[krazykat]

Removing my BRP Driver Backrest from 2014 RT Ltd to put on new RT Ltd. It was installed by someone else and I don't know if those nuts under the seat are captive to the seat or are they installed when original installation is performed. I'm referring to the 4 nuts that hold the bracket which is screwed to the underneath of the seat.

 

[Little Blue]

Seat Nuts

On my '16 RTL the nuts were fixed in the seat. Install the bracket with the supplied bolts. I installed my BRP Backrest on my standard BRP Seat. Good Luck. :thumbup:

 

[krazykat]

On my '16 RTL the nuts were fixed in the seat. Install the bracket with the supplied bolts. I installed my BRP Backrest on my standard BRP Seat. Good Luck. :thumbup:

Thanks Little Blue. That's what I kinda figured.

 

[BLUEKNIGHT911]

THE BACKREST

On my '16 RTL the nuts were fixed in the seat. Install the bracket with the supplied bolts. I installed my BRP Backrest on my standard BRP Seat. Good Luck. :thumbup:

Those nuts are in a small plastic holder (?) and can easily be damaged by to much force/pressure etc. So let the lok-tite do the job of holding the threads together ....... been there- done that ...... Mike :thumbup:..........PS I changed the BRP torx bolts with 10mm hex heads ....they are so much easier to work with ......:clap:

 

[krazykat]

Those nuts are in a small plastic holder (?) and can easily be damaged by to much force/pressure etc. So let the lok-tite do the job of holding the threads together ....... been there- done that ...... Mike :thumbup:..........PS I changed the BRP torx bolts with 10mm hex heads ....they are so much easier to work with ......:clap:

Thanks Mike from a fellow Vermonter (Newport).....

 

[Bob Denman]

I'll be swapping mine over into the bike also. :yes:
The Torx bolts seemed to remove okay; I get the impression that it will be an easy swap.



And this is the THIRD RT to use this backrest: I bought it used. :thumbup: