Any LED H-lights & Fog/D-lights that fit with NO changes?

[DJS5578]

Hi everyone, I'm new to the world of Can-Am!! (except for SLEDS and Outboards) Just bought new 2022 Spyder F3-T, 2 months ago. Im SERIOUSLY looking for a good pair of LED upgrade headlights. I bought a set previously, come to find out, Im unable to re-install the "protective rubber boots", without just leaving them off or make some "retro cuts". I'm NOT interested in making ANY changes to what's been installed from factory, except for changing out headlights and installing fog/driving lights, AT THIS TIME. Is there any LED's out there that will just fit into the "sockets" with the clamp holding the bulb, and able to re-install rubber boot? Any help or suggestions will be GREATLY appreciated. THANKS

Headlights/Hi/Low= North American Model= 2x 55/60 W (type HB2)

I'm also looking for "PAINT CODE" for my Hot Rod. I understand, the "GLACIAL BLUE METALLIC" was only produced for couple years ??

2022 F3-T Glacial Blue Metallic

 

[tekslk]

I ordered my leds for my 2021 F3L from sling mods I got the ones that were marked 360 they work great and are bright, I installed them with the factory rubber boot. I never had the plastic off before but it wasnt that bad to do. small hands help.

 

[DJS5578]

I had purchased the “Elite” LED headlight bulbs from sling mods. After 2 plus hours of trying how to get the darn boot to fit, called them, was told didn’t need to use “rubber boot” because bulbs are extreme waterproof grade. Or I could cut out some of the boot so can install. Nope, they accepted a return for me.

 

[BLUEKNIGHT911]

Hi everyone, I'm new to the world of Can-Am!! (except for SLEDS and Outboards) Just bought new 2022 Spyder F3-T, 2 months ago. Im SERIOUSLY looking for a good pair of LED upgrade headlights. I bought a set previously, come to find out, Im unable to re-install the "protective rubber boots", without just leaving them off or make some "retro cuts". I'm NOT interested in making ANY changes to what's been installed from factory, except for changing out headlights and installing fog/driving lights, AT THIS TIME. Is there any LED's out there that will just fit into the "sockets" with the clamp holding the bulb, and able to re-install rubber boot? Any help or suggestions will be GREATLY appreciated. THANKS

Headlights/Hi/Low= North American Model= 2x 55/60 W (type HB2)

I'm also looking for "PAINT CODE" for my Hot Rod. I understand, the "GLACIAL BLUE METALLIC" was only produced for couple years ??

2022 F3-T Glacial Blue Metallic

I was curious after I read one said slingmods worked another said it didn't???? .... So I looked at a parts fiche and BRP doesn't list a rubber cap for the back of the bulb ..... have you looked at yours???? .... I found a pair of really great LED's that are a lot less expensive than Slingmods and throw a very bright long range pattern .....Mike :thumbup:

 

[RiderDuke]

DJS5578...I put these in my 2021 F3-T From Lamonster Garage... Easy install and the rubber boots fit perfectly
https://www.lamonstergarage.com/lam...light-for-f3-st-parts-accessories-motorcycle/

I also put these fog lights on at the same time... I already had the plastic off so what the heck....
https://www.lamonstergarage.com/ips-can-am-spyder-f3-led-fog-light-kit/

Paint code for Glacial Blue Metallic is BRP # is B-463... PPG # is 979430
I just had my BRP trunk I purchased painted to match my bike

 

[DJS5578]

Thanks so much for info, will check out and thanks for the paint code/s

 

[baxter]

I have a 2022 F3L Special and just a few hours ago replaced oem headlamp bulbs with Lamonster's
and was not that difficult and rubber boot no issue. went on easily. will check alignment this evening when dark.

 

[baxter]

Replaced OEM headlights and then OEM fog lights with lights from Lamonster. Plug and play. much better than original. Good quality.

 

[alexf415]

I ordered my leds for my 2021 F3L from sling mods I got the ones that were marked 360 they work great and are bright, I installed them with the factory rubber boot. I never had the plastic off before but it wasnt that bad to do. small hands help.

What panel did you remove to access the headlight bulb?