Hello everyone, I love this site and the way it provides so much useful information. My Spyder is a 2011 RTL. I have searched and can't find the answer to my question. Any help will be appreciated.
I want to install an amp, new speaker wires will be run from the amp to each speaker. I will tape the ends of the old speaker wires at the speakers and leave them in place. The high level speaker input will be used to input signal to the amp. Can I use T-Taps on the 8 speaker wires coming from the radio harness. I'm trying not to cut any wires in the harness. Will this work?
I want to install an amp, new speaker wires will be run from the amp to each speaker. I will tape the ends of the old speaker wires at the speakers and leave them in place. The high level speaker input will be used to input signal to the amp. Can I use T-Taps on the 8 speaker wires coming from the radio harness. I'm trying not to cut any wires in the harness. Will this work?
hyea: … I'm a DIY'er and found this on my 2014 RT which has the same radio yours does. …. the main problem is the OEM speakers aren't very high quality, putting in a more powerful AMP isn't going to make the speakers BETTER.... A poor sounding speaker CAN'T be fixed with an AMP ….. I swapped out mine for JBL 2 Ohm models and my rears are now a full 5.25 size …. I don't play mine at full volume because it hurts my ears …. yep they are that good ….. so imho don't bother with the AMP ...unless you upgrade the speakers first ….And all four have to be changed, otherwise you will only notice the bad ones …… good luck …. Mike 
