A little help pleas

[JCSMOKE]

Putting the jigsaw back together after the parts came back from paint and the frunk release is now activated at all times so I can't close it without playing with the wiring. I think this may be because that switch came apart during tear down:banghead: so I need a new one I think. If one of you search engine ninjas could do your voodoo find the post from a little while back where someone posted a link to a company that could sell any part of the spyder needed. Not sure where I am going to go with this but just something for me to think about before pulling the switch and attempting to repair it myself.

 

[NancysToy]

Check to see if you put the switch wires on the wrong terminals, especially the microswitch.

 

[CyncySpyder]

Ours broke a couple of times now & was covered under Warranty

Can't hurt to see if your dealer can get one replaced for you under Warranty for free

 

[kawakii]

Freedom Cycle in NH website lets your buy any OEM part and have shipped to you online. Might be an option if you don't live near by a dealer to go in a buy the part.

 

[jimclarkf1]

The EASY WAY OUT

take it to the dealer, and trade it in on a NEW SPYDER