7jurock on F3 Ltd size suggestion?

[Gcclubs]

I am interested in the size 7jurock shield you use if you are tall. I am 6’4” and want to look over the shield. Would the 24” wideboy be to tall? The 7jurock site doesn’t seem to have any size to height advice or measurements. Let me know how tall you are, which size screen you use and if you look over or thru. Thanks everyone

 

[Peteoz]

You might like to add your inleg length to that question, Gc. Someone the same height as you may have a much shorter or longer inleg, meaning the screen won’t fit as you would like. Have you tried calling 7Jurock? They may be able to supply exactly the info you need re measurements.

Pete

 

[RICZ]

7Jurock measures height from to to bottom of the plastic along the centerline. They will make any height and w/s you want and not charge more than the going price that height. Always get the flip, they work! The flip allows a shorter w/s to perform as if it was taller.
To check for the height you want, clip or tape a piece of cardboard to the top of the w/s and go riding. Raise or lower it until you get the height you want. That's it! Call them, they are easy to work with. And yes, I have one of their customs made to my specs. It's 9" wider than stock and uses the stock brackets.

 

[Gcclubs]

Good suggestion. For my height I think my inseam is on the short side at 34”

 

[Gcclubs]

7Jurock measures height from to to bottom of the plastic along the centerline. They will make any height and w/s you want and not charge more than the going price that height. Always get the flip, they work! The flip allows a shorter w/s to perform as if it was taller.
To check for the height you want, clip or tape a piece of cardboard to the top of the w/s and go riding. Raise or lower it until you get the height you want. That's it! Call them, they are easy to work with. And yes, I have one of their customs made to my specs. It's 9" wider than stock and uses the stock

View attachment 188923

. Thanks I will try the cardboard tip. Is yours based off of the tall boy model?

 

[johnv50]

As per the recommendations of RICZ I had 7Jurock make a custom wider shield, but I am shorter than you. If you call them they may be able to make what you want, or at least make a recommendation.

johnv

 

[RICZ]

. Thanks I will try the cardboard tip. Is yours based off of the tall boy model?

No...it's my own design.

 

[Rattlebars]

One can add an 11.5 inch (280mm) Moparty extender which adds much more for height protection while still allowing one to look through the space as if looking over the shield. I was particularly impressed by its ability to prevent the buffeting on the helmet by this addition. I have also added Slingshot extenders to the side. You will find that when you protect from the front, you will get a BACKDRAFT which is a wind from the rear as the vacuum from behind the shield will suck air onto your back and neck. I encountered that with my GL1800 and worked through a few solutions to that on my BACKDRAFT page.

https://www.rattlebars.com/chetswing/backdraft.html



Full details & links on my page "click: 2016 F3-T and many how to's under AIR CONTROL.