2021 RTL panel removal

[Mike0123]

I saw the Smoaks video on YouTube on removing the 2020 panels. I am assuming they are the same, look to be. Anyway, in the video he talks about taking the panels off, but doesn’t show how he did it. He takes off that black audible cover??? pauses the video then next shot all three panels are off. So here I am in my shed with Dudley, trying to figure this out. I was hoping for a little clarification and advice.

I did try searching but didn’t seem to come up with anything satisfactory, so if this has been asked and answered I apologize in advance

 

[MONK]

https://www.spyderlovers.com/forums/showthread.php?137833-2020-RT-side-panel-removal

That covers the (3) panels you'll use most often.

https://www.spyderlovers.com/forums...-install-frunk-liner-on-2020-RT-base-standard

That covers removing the front end.

 

[WilcoJunoHotel]

Looking at your picture, the next panel to remove is the smaller lower one that is below the seats. It just pops off working from the back to the front. Unsnap it from the area near the passenger foot peg and then slowly release it moving to the front. IIRC, there are maybe 4-6 friction spring clips that hold it in place.

Then the large front piece comes off which is more complex because it has a combination of torx screws (3?), push pins and friction spring clips. The push pins are up in the frunk area (2 or 3 of them IIRC). I think the little louvered center piece in the middle of the frunk needs to come out too - it pops out by pushing in on both sides.

Go slow and don't force things (DAMHIK) - once you do it a couple of times, it is a lot easier.

 

[Mike0123]

Ok! Thank you... let’s give this a try!

Tomorrow ....
..football time now.