2015 RTS Miss Fire Problem

[longislandspyder]

I am having a misfire at low RPM's and when rolling off in first gear from a stop it miss fires, hesitates and then surges in RPM's. 2015 RTS only 2,010 miles on it. Need help please. Thanks.

 

[Bob Denman]

Have you tried pulling up any error codes when it starts to do this?
It almost sounds as if your bike is going into Limp-Mode... nojoke

 

[longislandspyder]

Have you tried pulling up any error codes when it starts to do this?
It almost sounds as if your bike is going into Limp-Mode... nojoke

How do I pull codes?

 

[Bob Denman]

This only will pull active codes, so you have to perform this exercise when the bike is acting up...
Lay your left thumb across the "Mode", and "Set" buttons...
Then find another thumb, and use it to push in the turnsignal switch (just like cancelling a turnsignal)
Any active codes will display on the main screen
WRITE THEM DOWN... and you can either ask us what they mean; or get a shop manual, and look them up.
Good Luck! :thumbup:

 

[longislandspyder]

This only will pull active codes, so you have to perform this exercise when the bike is acting up...
Lay your left thumb across the "Mode", and "Set" buttons...
Then find another thumb, and use it to push in the turnsignal switch (just like cancelling a turnsignal)
Any active codes will display on the main screen
WRITE THEM DOWN... and you can either ask us what they mean; or get a shop manual, and look them up.
Good Luck! :thumbup:

Thank you I will try it later when I get home. Can I do this without turning on the Engine?

 

[Bob Denman]

I'm about 99% sure that at the very least: the ignition switch will need to be on...
I've only pulled mine with the bike running...

 

[longislandspyder]

I'm about 99% sure that at the very least: the ignition switch will need to be on...
I've only pulled mine with the bike running...

I try to pull the codes, but the screen goes blank, so I assume there is no code error?

 

[Bob Denman]

That is correct; it's time to let your dealer take a peek under the plastic...