License Plate Relocator HELP

[David Gaspari]

Can anyone help me find a Evoluzione plate relocator kit (they are out of business) or something similar that moves the plate directly above the rear tire? Thanks David

 

[Chupaca]

Little checking..!!

Ebay has a lot of rear fender replacement kits moving the plate up but eliminating the oem rear fender. Have a look..:thumbup:

 

[MikeinGA]

Like this?

EBay: http://www.ebay.com/itm/Black-Motor...Model:Spyder+RS-S&hash=item35e1ff03c9&vxp=mtr

Mike

 

[billybovine]

This may be an option for you from BRP.

 

[Cruzr Joe]

It always helps if we know what Spyder you have ......................... The easiest way is to put your Spyder info in your signature.


Cruzr Joe

 

[David Gaspari]

2013 RS-S

Sorry. 2013 RS-S. I removed the rear fender. I bought a led lighted license plate frame and an aluminum bracket. I am mounting the tag using the existing screw under the rear between the brake lights. I re used the original power supply. I will post photos when done. The lower belt guard goes back on. I wish the aftermarket companies would sell a complete belt guard. Thanks

 

[llyrad]

Sorry. 2013 RS-S. I removed the rear fender. I bought a led lighted license plate frame and an aluminum bracket. I am mounting the tag using the existing screw under the rear between the brake lights. I re used the original power supply. I will post photos when done. The lower belt guard goes back on. I wish the aftermarket companies would sell a complete belt guard. Thanks

Did you get a chance to take some photos of the finished product?

 

[David Gaspari]

Final License Plate Rolocation

Did you get a chance to take some photos of the finished product?

Here is the final product. after removing everything I moved the license plate light harness to under the seat and cut the harness leaving enough wire so I could re hook it back up later. I bought a led illuminated license plate holder with led lights built in the frame hand hooked up the power. I bought an aluminum license plate bracket on Ebay used made for Harley Davidson bobbers. I reused the single bolt that is under the seat and bent the license plate holder to the correct angle. super clean installation, no new holes or new wires to run. clears the tire ALL the time even with two up. really came out great. Thanks David

 

[Spyda98]

Here is the final product. after removing everything I moved the license plate light harness to under the seat and cut the harness leaving enough wire so I could re hook it back up later. I bought a led illuminated license plate holder with led lights built in the frame hand hooked up the power. I bought an aluminum license plate bracket on Ebay used made for Harley Davidson bobbers. I reused the single bolt that is under the seat and bent the license plate holder to the correct angle. super clean installation, no new holes or new wires to run. clears the tire ALL the time even with two up. really came out great. Thanks David

Looks good.. I was trying to find the evoluzone also... then was going to go the ZX-14 route.. then I just went ahead and got the BRP Sports fender. Installed it this weekend and so far I like it better than the stock wheel fender.