• There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.

Any suggestions on a Torque setting recommendation for Lamonster belt vibration dampener?

SpyderEnzo

New member
Any suggestions? I haven't heard back from Lamonster yet. I've preliminary torqued it to 15 foot pounds. This would be the two mounting bolts on a 2025 RT Limited. Thank you in advance
 
No matter what vibration dampener you install check the bearing frequently for safety because when that little bearing explodes and you continue on down the road, you'll wish you'd never installed it to begin with. Luckily, I removed mine before that happened, but some folks ruined their belts because they didn't remove/replace the bearing in time.
 
The stock BRP dampener roller and bearing will give out a lot sooner than the IPS version from Lamonster Garage. I've seen some nasty grooves worn into the roller surface even before the bearing failed.
 
No matter what vibration dampener you install check the bearing frequently for safety because when that little bearing explodes and you continue on down the road, you'll wish you'd never installed it to begin with. Luckily, I removed mine before that happened, but some folks ruined their belts because they didn't remove/replace the bearing in time.

Jacob, at Lamonster, recommends replacing the roller every 15,000 miles. Mine has approx. 8K on it now and feels solid.

89114fc3-cbad-4369-afed-26a9767204db.jpg
 
Just an added note: Make sure the roller arm is perfectly parallel with the belt and the roller is making full contact on the belt. If the arm is not installed parallel to the belt, you risk putting an extra load on the bearings in the roller and possibly causing the bearing to prematurely fail later down the road. Also use Blue loctite on the 2 bolts.

20261105_122434.jpg
 
Jacob, at Lamonster, recommends replacing the roller every 15,000 miles. Mine has approx. 8K on it now and feels solid.

View attachment 257823
Just for what it's worth, if I remember I finally took mine off and tossed it. No, I think I gave it away to another member on this site. Anyway, I got rid of the suspense of wondering when this sucker was likely to explode on me and cost me $300/$500 to repair the damage it could cause. I adjusted my belt tension to where it produced the least amount of annoyance at the cruising speed I normally rode at. Nothing I've ever owned with 2,3, or 4 wheels, tracks, or with a prop, ever ran perfectly W/O any annoyance whatsoever.
 
Back
Top