Any good Cup holders for 2020 RT?

[Pennyrick]

Has anyone found a good drivers cup holder that fits on the 2020 RT?

Pennyrick

 

[sduskin]

I ordered LaMonster's yesterday after reading a forum post where a rider drilled and tapped the cable shield for a ball mount. LaMonsters comes with a bottle holder.

 

[bikerbillone]

Interesting, can you post a link or pic? I have problems trying to negotiating Lamonster's web site and finding an item I'm looking for. Thanks.

 

[CentralCoastCA]

https://www.lamonstergarage.com/can-am-spyder-top-cuff-with-drink-holder-lamonster-ips/

Or this one

https://www.lamonstergarage.com/can-am-spyder-top-cuff-with-adjustable-drink-holder-lamonster-ips/

 

[mrwog]

I had my wife hold my cup while I went riding.... it was not in her hand when I returned..... Haha just kidding just kidding.

 

[bikerbillone]

Thanks CentralCoast..

 

[KX5062]

The Lamonster one looks like a really nice piece of kit. However, it also looks like with the short bars on the stock 2020 RT the drink cup holder might get in the way.

 

[NEXUS]

Finding a place to put a cup Holder on the 2020 RT was a little bit limited.
I found a place and a way to get it out of the way and still be accessible.

Where I ended up putting it at works just fine but it's a little complicated to do
but doable for most anybody. If you want to step-by-step instructions send me
a PM

Cost from GPSCity.com was $41.00 which is free shipping. Add another
$4.00 for the screws and locking nuts from Lowe's.

I put one on both sides. While I had it off, so the cost is for two mounts
as you can see in the pictures. I may use the other one for camera mount later.

 

[mr z]

I use a Butler Cup. Works great.

 

[samewok]

I use the top cuff from Lamonst

 

[scooterexpress]

Has anyone found a good drivers cup holder that fits on the 2020 RT?

Pennyrick

glassact.com

 

[Pennyrick]

Finding a place to put a cup Holder on the 2020 RT was a little bit limited.
I found a place and a way to get it out of the way and still be accessible.

Where I ended up putting it at works just fine but it's a little complicated to do
but doable for most anybody. If you want to step-by-step instructions send me
a PM

Cost from GPSCity.com was $41.00 which is free shipping. Add another
$4.00 for the screws and locking nuts from Lowe's.

I put one on both sides. While I had it off, so the cost is for two mounts
as you can see in the pictures. I may use the other one for camera mount later.

View attachment 180293

View attachment 180294

View attachment 180295

View attachment 180296

Thanks for the response as well as the PM with more details. Much too in involved for me. Kind of like building a watch to tell the time but appreciate your efforts.

Pennyrick

 

[ARtraveler]

We bought a pair last OCT at the Green Country Jamboree in OK. They were from a place called Diamond R Accessories. They fit nicely on on 2014 RT and 2011 RT. I changed out the one from my 2011 and put it on the new 19 F3. I am thinking the 2020 set up is similar. Diamond R should know. Two longer screws replace the ones that are standard on the right hand side handlebar control panel. Took me all of five minutes to make the change out.