Number plate cable

[Rigsby]

Hi, I have just bought an F3s and the previous owner took the rear mud guard and number plate unit off. I have bolted it back on but I don't know where the electrical plug goes. There is a harness with a moulded plug on it which I have clipped into the top chassis rail on the right hand side of the bike and it reaches to about the middle of the drivers seat but I can't see where it plugs into. Don't want to start taking off parts of the body if it isn't required. I took the seat off but there wasn't a spare plug under there. Any help will be appreciated, thanks Rigsby

 

[Dave7691]

Hi, I have just bought an F3s and the previous owner took the rear mud guard and number plate unit off. I have bolted it back on but I don't know where the electrical plug goes. There is a harness with a moulded plug on it which I have clipped into the top chassis rail on the right hand side of the bike and it reaches to about the middle of the drivers seat but I can't see where it plugs into. Don't want to start taking off parts of the body if it isn't required. I took the seat off but there wasn't a spare plug under there. Any help will be appreciated, thanks Rigsby

If you look on the right side rear frame rail you should see it if my memory is correct . It's been a while since I put my fender kit on near the swing arm pivot point .
Hope that helps.

 

[Dave7691]

chopped fender instructions

If you look on the right side rear frame rail you should see it if my memory is correct . It's been a while since I put my fender kit on near the swing arm pivot point .
Hope that helps.

Hi if you look up Part number (SKU) : 219400597 BRP installation instructions this is what you look for right side lower panel.take extra care when putting the 4 body screws back in if you have a wire wheel you should take off all the loctite off them as they are known to screw up the brass inserts when you put them back in. Dave

[TABLE="class: noBorder, width: 100%"]
[TR]
[/TR]
[/TABLE]

 

[Dave7691]

Hi if you look up Part number (SKU) : 219400597 BRP installation instructions this is what you look for right side lower panel.take extra care when putting the 4 body screws back in if you have a wire wheel you should take off all the loctite off them as they are known to screw up the brass inserts when you put them back in. Dave

[TABLE="class: noBorder, width: 100%"]
[TR]
[/TR]
[/TABLE]

 

[Rigsby]

Hi if you look up Part number (SKU) : 219400597 BRP installation instructions this is what you look for right side lower panel.take extra care when putting the 4 body screws back in if you have a wire wheel you should take off all the loctite off them as they are known to screw up the brass inserts when you put them back in. Dave

[TABLE="class: noBorder, width: 100%"]
[TR]
[/TR]
[/TABLE]

Thanks Dave that is just what I needed:2thumbs: