Here is a picture of lights on a 2014RTS-SE6: Deanna
Current Spyder - 2023 F3 LTD Special Mineral Blue
Red LED NANO Saddlebag Marker Lights with Full Illumination
Sequential Fender LED'S (Amber/Red) with Safety Reflector
Dual Power Plate (12 V & USB ports)
Gremlin Bell
Rear Trunk Organizer (4 holders, 2 Elastic Holders)
Lamonster "Top Cuff" with adjustable drink Holder
SpyderPops Missing Guard Belt
Console Accent Trim (Carbon Fiber Domed Black)
Ultimate F3 Floorboards
Front Fairing Service Access Door Covers (Carbon Fiber Doomed Black)
Sway Bar with Links
Rolo Laser Alignment
Half Cover
A-Arm Daytime Dual Color LED Running Lights with Blinker Module
Hi-Viz DRL and Sequential Mirrors lights
Marinco 12Volt Power Receptacle with polarized leads & slide lock
Show chrome Trunk Shock
I have a 2014 RT and was wondering if you can install the RTS fog lights on the RT?
They're a bit pricey but they do look bad going down the road.
New Spyder Owner
Jeff from Michigan
Yes, and with LED replacement lamps now available from a couple of the SL sponsors, on the home page, it's a worthwhile consideration. That is, if the price isn't an obstacle for you. I would have considered doing so two years ago for my 2013 RT but good LED lamps weren't available then and I couldn't see spending $500 for incandescent fog lamp units. I put LED auxiliary lights on the fenders.
2014 Copper RTS
Tri-Axis bars, CB, BajaRon sway bar & shock adjusters, SpyderPop's Bumpskid, NBV peg brackets, LED headlights and modulator, Wolo trumpet air horns, trailer hitch, custom trailer harness, high mount turn signals, Custom Dynamics brake light, LED turn signal lights on mirrors, LED strip light for a dash light, garage door opener, LED lights in frunk, trunk, and saddlebags, RAM mounts and cradles for tablet (for GPS) and phone (for music), and Smooth Spyder belt tensioner.
Front fenders already have LED's (makes a difference) - If I have done my research right the fog lights are Plug & Play - So will they turn on when you start the Spyder ?
Front fenders already have LED's (makes a difference) - If I have done my research right the fog lights are Plug & Play - So will they turn on when you start the Spyder ?
Excellent question ... that I don't have the answer for. On the RT they are switched on by a switch on the bank of switches in front of the glovebox. I'll assume you either have to wire in your own switch or connect that circuit to your headlamps. If you do the latter, you might have a fuse capacity issue.
2020- RT Limited
Chalk White, Can-Am rear passenger armrests, Comfort Seat, Grip puppies, RAM Cup Holders, Providence RAM Mount
FOBO2 TPMS
Aluma MCTXL trailer
BRP hitch
Big Bike Parts wiring harness
Permanent Smile!!!
Front fenders already have LED's (makes a difference) - If I have done my research right the fog lights are Plug & Play - So will they turn on when you start the Spyder ?
Originally Posted by OverHillAndDale
Excellent question ... that I don't have the answer for. On the RT they are switched on by a switch on the bank of switches in front of the glovebox. I'll assume you either have to wire in your own switch or connect that circuit to your headlamps. If you do the latter, you might have a fuse capacity issue.
The plug is already there. You need a two conductor Delphi 1.5 connector to plug into it. The switch connector is in the switch group on the dash. You can either buy a switch from the dealer or find, and probably slightly modify, a Carling switch that will fit. That is what I did. The BRP kit will have the switch in it and the lights will plug right into the existing harness.
They turn on when the switch is on and the engine is running.
Last edited by IdahoMtnSpyder; 04-13-2016 at 01:37 PM.
2014 Copper RTS
Tri-Axis bars, CB, BajaRon sway bar & shock adjusters, SpyderPop's Bumpskid, NBV peg brackets, LED headlights and modulator, Wolo trumpet air horns, trailer hitch, custom trailer harness, high mount turn signals, Custom Dynamics brake light, LED turn signal lights on mirrors, LED strip light for a dash light, garage door opener, LED lights in frunk, trunk, and saddlebags, RAM mounts and cradles for tablet (for GPS) and phone (for music), and Smooth Spyder belt tensioner.
Plug & Play would be nice but I found some rocker switches that I could wire up - That way I don't have to worry about fuse issues
Sounds like it's going to be a nice weekend - Finally a chance for a decent ride.