I drilled a small hole behind the mirror glass about center and at the opposite end of the mounting end of the assembly to the bike. I just pushed the glass in on the inside edge nearest the bike which created just enough space to use the drill bit. I then used a long zip tie to fish back and with patience came out the same hole as the existing wiring. I taped the wires in just before the connector and it works fine with no disassembly required.
If memory serves me correct. I used bluestratos instructions to install my lights
Is it Friday yet? ... Oh yeah, I forgot. I'm retired
Past bikes
2010 RS - Sold
2012 RT - Sold
2014 RT - Testing completed
2016 F3-T Audio package - Sold
Personally, I would suggest the LED strip not arrows for RS
2012-03-17 19.41.22.jpg
As stated, the RS mirrors are smaller than the RT's, so I personally wouldn't want to block any of what little you have. But you could probably put on some of the LED light strips on the edges.
Last edited by CyncySpyder; 03-29-2013 at 12:41 PM.
Went for the stick ons, tried to get the clips off but being a 2010 they are getting brittle. So I got the bottom on both sides which allowed to open up a bit, drilled the hole and fished the wire out through original hole and spiced. All is good!
Originally Posted by bluestratos
Reply With Quote
Personally, I would suggest the LED strip not arrows for RS
I think that somebody even has a set of lights designed for that usage... (I just don't remember who! 
)
