What's the Proper routing for BRP trailer harness on 2020 F3-Limited?

[motoswami]

Hey Folk:
Gotta ask for help. The instructions I've managed to find for installing the BRP accessory trailer wiring harness on my 2020 F3-Limited don't seem to cover one critical area -- where should the final wire from the module be routed once it passes underneath the passenger seat toward the rear end?

I've raised the top box to access this area, but don't see any logical hole it should pass through and route on down to run along the top left rail of the hitch.

How much plastic do you have to remove to guide the wire along the proper path?

 

[PW2013STL]

This is all I found for mounting the wiring kit from BRP

https://instructions.brp.com/conten...Hitch Kit and Control Module&rel_part_number=

 

[Copperman]

I read it wrong.

 

[motoswami]

This is all I found for mounting the wiring kit from BRP

https://instructions.brp.com/conten...Hitch Kit and Control Module&rel_part_number=

Hey PW:

Thanks for that. It's not quite the same parts as came with my kit (PN 219401094 -- which if you plug into "Instructions" on the BRP website you get a dumb look), but it confirms what's gotta be done.

 

[motoswami]

Thanks for the help. Using a little redneck creativity, I got the job done. Worst part was running the trailer connection cable (the 4-pin deal) from under the seat area back through the labyrinth of plastic barriers so it would hang down to the hitch area.

Glad that's done. Now to get the TimeOut cargo trailer out of the barn, hook it up, and figure out where we want to go first. Woo-hoo!

Should be a sharp-looking rig; both units (trailer and trike) are shiny black with chrome accents. I might even change the signature photo (you guys tired of looking at that Enfield yet?).