ISCI Fan Can

[ISCI Billy]

ISCI is now taking pre-orders for this new product. The retail cost is $92.00 each. It is for the RS only.

*Made from Anodized Aluminum with Stainless Steel Rivets.
*Does not put any additional strain on the radiator fan motor.
*Does not increase coolant temperature.
*Reduces the temperature of air exiting the side vent significantly.
*We have tested the Fan Can for the past 9 months in the HOT Alabama Summer with no issues.
*Very easy to install.
*Made in the USA!

Give me a call to place an order at 1-800-838-9421.

 

[wyliec]

ISCI is now taking pre-orders for this new product. The retail cost is $92.00 each. It is for the RS only.

*Made from Anodized Aluminum with Stainless Steel Rivets.
*Does not put any additional strain on the radiator fan motor.
*Does not increase coolant temperature.
*Reduces the temperature of air exiting the side vent significantly.
*We have tested the Fan Can for the past 9 months in the HOT Alabama Summer with no issues.
*Very easy to install.
*Made in the USA!

Give me a call to place an order at 1-800-838-9421.

That looks an awful lot like the Air Mgmt. System from spyderpops. Of course I could be wrong.

 

[mtdoragary]

I've got Spyderpops kit and I've seen the can. There is no similarity. The can directs the air AWAY from the side vent and down under the bike.

 

[SpyderDog65]

Nice FINALLY somone invented somthing smart ) Ty I will be calling u wed when I get paid )

 

[YPILOT]

I got this shot of the fan can at SITS.

 

[SpyderWolf]

Thanks for the heads up Billy. :2thumbs:

 

[ISCI Billy]

Do you have any photos of the install with the side cover off? Also I've forgot how you get the redirected hot air out. Are you running a vent hose to the bottom of the bike or does the can just direct the air out the bottom through an existing hole or one that needs to be made? Last question are you planning on offering the temp gauge set up?

The Fan Can redirects the air out the bottom of the bike. No modifications required to your Spyder. The temp gage set up was something we did to test the Fan Can over the summer. Not sure at this point if we will offer this set up as this is not something that we manufacture.

 

[canam9]

Waiting for the RT model.opcorn: :ani29:

 

[BMF_RACING]

Waiting for the RT model.opcorn: :ani29:

still waiting I suppose? :dontknow:


I will be making one for my RT, before the hgwy pegs ... its a must or right side peg is useless.:sour:

 

[Venom21]

RT Fan Can Model

We had some manufactured, but after field testing them we had to make a few modifications. Should be complete very soon so that we can bring some to Spyderfest.