How warm must it be to install Spyderpop's Belt Guard and Custom Dynamic's HMT Light?

[GuitarPlayer]

My RT-Limited is still at the dealer getting the ball joints replaced before they deliver it to me.

I've received both the Spyderpops Belt Guard and the Custom Dynamics HMT Brake light. I see that they both have an adhesive to attache them to the Spyder. My question, is how warm does it need to be before I do the installation? I'll do this in an unheated garage.

Thanks,

Tony

 

[asp125]

No problem, just warm the area with a hair dryer.

 

[GuitarPlayer]

Hadn't thought of that. I may try that.

Thanks,

Tony

 

[jerpinoy]

How big is you hair dryer?I hope you get very tiny garage. just kidding. :joke: Make sure you wipe the area clean with mineral spirit. This will clean out oily stuff.:yes: Have fun

 

[GuitarPlayer]

Actually, I've got a heat gun. I'll also wait until it gets above freezing before I do anything.

Tony

 

[Bob Denman]

I seem to think that I've heard folks mention 60 degrees as the entry ticket to working well with adhesives...

 

[grumpybob]

My RT-Limited is still at the dealer getting the ball joints replaced before they deliver it to me.

I've received both the Spyderpops Belt Guard and the Custom Dynamics HMT Brake light. I see that they both have an adhesive to attache them to the Spyder. My question, is how warm does it need to be before I do the installation? I'll do this in an unheated garage.

Thanks,

Tony

I just looked up Iowa state laws and - sorry to say both items are illegal in your state, You must send them to me ASAP or you will be arrested. :yes::yes:


Sounds like you are all set, have fun.

 

[GuitarPlayer]

I just looked up Iowa state laws and - sorry to say both items are illegal in your state, You must send them to me ASAP or you will be arrested. :yes::yes:


Sounds like you are all set, have fun.

Too bad, so sad...:joke:

Thanks,

Tony