• There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.

Recent content by SpyderAndy

  1. S

    Floor boards for 2012 rss

    I have the bigger brake bad on my RS. It works with the boards but it hangs over the board quite a bit. It makes it hard to use the center of the board because your foot is under the brake. I'm saving up to get the hand brake so I can put the small pad back on and open up more space. I usually...
  2. S

    Floor boards for 2012 rss

    I just put the rivco boards on my 2012 RS and I like them so far.
  3. S

    2012 RSS - does it have Cruise?

    I wasn't sure if the 2013had cruise or not. I checked the BRP web site before posting and it showed cruise N/A. After you posted a dug a little deeper and sure enough on the build your own page it lists cruise. I've learned something new.
  4. S

    Diagnostics / BUDS

    There was a thread about this some time back. If I recall correctly no one had tried it and most people were skeptical about it. I'm sure others will chime in as well
  5. S

    2012 RSS - does it have Cruise?

    Sorry no cruise control on the RSS. You have to go with an RT Or one of the new ST's for cruise
  6. S

    Rivco driver floorboard install help 2012 RS

    Finally got them installed. Getting the new bolt in the right side mount was tough. I ended up feeding a shoe lace through the mount and super gluing one end to the bolt. Once I did that I simply pulled the string until the bolt hit the mount. Then I just used a screwdriver to lift the bolt head...
  7. S

    Rivco driver floorboard install help 2012 RS

    Ok I got both frame bolts off. It's amazing what a hammer and some "TLC" will do. Lest side basically done. Now I have a new problem. I can't figure out how to get the replacement right side bolt in. The only access is all the way on the left side and in order to line the bolt up the head has to...
  8. S

    Rivco driver floorboard install help 2012 RS

    Ok so I feel a bit silly but I need some help with the rivco driver floorboard install. I tried to install them today and only made it to step two before running into an issue. Step two is when you remove a 15mm nut from the bolt attached to the engine case so that you can remove the bolt and...
  9. S

    600 mile Maintenance

    You should be fine. Lots of people have gone past 600 miles. Mine was done closer to 1000 miles and my dealer had no problem with it. I don't thin I would push past 1000 though. I'm sure others with more technical knowledge will give you some good feedback.
  10. S

    Where is the Relay box located on the 2012 RS.

    It is right under the top edge of the frunk lid. You could say under the handlebars. There is a graphic of a pc keyboard and a thermometer on the left side of the cover I think. I can't get a picture for you at the moment but I am sure someone will post one if you still can't find it. I missed...
  11. S

    Where is the Relay box located on the 2012 RS.

    I don't have a pic but if you open the frunk there is a diagnostic cover at the very top. It runs all the way from one side to the other and dips down around the latch. Pop that cover off and you will find a fuse box you are looking for.
  12. S

    What windshield do you recommend on the RS for freeway driving?

    I just put a madstad 20in on my RS. It isn't dialed in yet but it's still very nice. If you are concerned about the look I would get a tinted shield. I got a clear one and I think a tinted would look nicer but for function what I have is great.
  13. S

    GPS MOUNT LOCATION ON 2012 RS

    That is exactly the type of install I am looking to do. If you have some pics of how you ran the power that would be great
  14. S

    Engine stall with SE5

    I have had an RS SE5 for about a month. I have not had any issue with reverse to first but I have had the hesitation with shifting. You are most likely shifting too soon. The SE5 will let you shift around 3000 RPM but its right on the edge of the clutch and you will get a hesitation. You will...
  15. S

    GPS MOUNT LOCATION ON 2012 RS

    I got a RS SE5 about a month ago and I am looking to mount a GARMIN NUVI 40LM to it. I ordered the U Bolt kit with the aqua box 6 from gps city but I found two thing that I didn't like. First the aqua box size is huge and second the handlebar location looks like it would be hard to see. I just...
See more
Back
Top