• There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.

Recent content by FryGuy

  1. F

    Signal Dynamics BackOFF Brake Hold Module Install

    Guess the answer is No. The module needs a Pulsing (square wave) Speed input (0-12 volt) usually on a transmission VSS (Vehicle Speed Sensor) that is a hall effect type (three wire) sensor. The Spyder has no such sensor, I can only see the Wheel Speed Sensors for the ABS/VSS/TCS system, the...
  2. F

    Signal Dynamics BackOFF Brake Hold Module Install

    Can you install one of these modules on the Spyder if so how do you do it? Signal Dynamics BackOFF Brake Hold Module
  3. F

    LED Tail Lights, Limp-Home Fix!

    I decided to install LED tail light bulbs in my Spyder and discovered the Limp-Home Mode. I seen the issue mentioned on here and have not seen anyone say about how to properly resolve this. I found from the schematics that only light bulbs brake circuit is monitored by the VCM. I played around...
  4. F

    Aftermarket HIDs on Spyder RT

    Problem Solved Problem completely solved. I built a custom relay harness all in loom kept it as far away any stock wiring (may not have been necessary for power wires). The main problem was the ballast location of the main lights. The bike does NOT like them (High voltage wires) anywhere near...
  5. F

    Aftermarket HIDs on Spyder RT

    They are the slim digital. My guess is that the stock harness has too small of wire gauge for the peak current draw for lamp ignition, Fogs are fused for 10 amps (headlights 30 amp) and peak current for lamp ignition is about 15 amps (combined about 30 amps plus the rest of the circuit draw)...
  6. F

    Aftermarket HIDs on Spyder RT

    Didn't know about them until now. Mainly just went with what I've used before. So I need a Relay harness for the fogs?
  7. F

    Aftermarket HIDs on Spyder RT

    I have Installed 6000k Light Purple HID s on headlights (H7) and Fogs (H8) they are 35 watts each. They are from www.v-hids.com I have bought these kits for all my vehicles and have no problems other then a few ballast failures. My spyder don't like them at all. I can run the headlights and...
  8. F

    What Accessories/Mods MUST I have for a New Spyder RS?

    Thank you, that's good to know.
  9. F

    What Accessories/Mods MUST I have for a New Spyder RS?

    Very nice, I'm amazed at the level of customization many of you have done. It truly makes the spyder personal.
  10. F

    What Accessories/Mods MUST I have for a New Spyder RS?

    That is good sound advice.
  11. F

    What Accessories/Mods MUST I have for a New Spyder RS?

    There is a sway bar, nice! I know a aftermarket sway bar made a huge difference in my cars steering accuracy and body roll, that low profile tires couldn't do alone. keep the recommendations coming.
  12. F

    What Accessories/Mods MUST I have for a New Spyder RS?

    I'm soon getting a 2010 Spyder RS, What accessories/Mods are must have for a short distance rider, mostly evenings/night? Some of these items are a must; JuceBox Stock exhaust sounds weak (what are the best sound and performance) (I like the hindle and the two brothers but what do you think?)...
See more
Back
Top