Curious if anyone has experience installing the Baja Ron wway bar on a 2019 F3S. Instructions contradict themselves regarding long bolt location, and don't even mention spacers included in the box..
Anytime you have an issue with any BajaRon product, question, whatever. You can always call or email me (info listed with all instructions).
The current version for the F3 is v3.0. If you don't have that version then you do not have the current set.
I have updated all of my vendors with current instructions. But that doesn't mean they are necessarily sending them out. Sometimes they build kits and put them on the shelf and they may sit there for awhile. Especially if they put new builds on top of the older builds. You're still getting the same product, just not necessarily the updated instructions.
If you send me your email address. I will send you a PDF copy of the latest version for your Spyder.
I had a similar question with my instructions. I contacted BaJaRon and within minutes he had the updated instructions emailed to me.
On a side note the sway bar seemed to be a very nice improvement. My wife was always holding on to the rear hand rails because of the bikes rocking motion. On our first ride, after the sway bar installation, she did not feel the need to hold on due to the ride being more steady. I also notice an overall improvement in both the curves and with reduced rocking. I’m happy with the install.
Poasttown