right side panel opening cover

[skeet]

I had a grill made for this opening, and would like to post a picture. Can't figure out how.This grill just has horozontial bars, and can be painted, powdercoated, or could be made of polished stainless steel. I like it better than the one that looks like a spyder web.

[ataDude]

How to post a pic... courtesy of Lamont:

Clicky: http://www.spyderlovers.com/forums/s...ead.php?t=8563

.

I had a grill made for this opening, and would like to post a picture. Can't figure out how.This grill just has horozontial bars, and can be painted, powdercoated, or could be made of polished stainless steel. I like it better than the one that looks like a spyder web.

[LDFIREWORKS]

send pics asap iam looking for one a long time

[Lamonster]

http://www.spyderlovers.com/forums/s...ead.php?t=8044

[skeet]

Thanks Lamont, but I get some kind of interference on that site--like 2 people trying to talk at the same time. One is very loud and the other very soft. The loud one keeps saying "Pictures on the twenty" over and over and the only way I could shut him up even going back to my home page, was to shut down the computer and re-start. Perhaps I'll try again later. JIM

[skeet]

This is another attempt to show a picture of the gril I installed.

[Roaddog2]

This is another attempt to show a picture of the gril I installed.

Nice Job

[NancysToy]

Very classy! Hard to tell from the pic, how much space is open, vs. the part with the bars? Looks to be about 50:50. Any cooling problems that you have noticed?
-Scotty

[bjt]

I think it looks good skeet.

[brutus450]

SKEET................that's the best lookin "filler" I have seen

NICE JOB

NOW........... I want to make something!

[skeet]

SUCCESS!!! When the panel is mounted on the bike, the bars are horizontal. The grill is not too difficult to install using 100% silicone, but I used small chrome bolts from the outside(visible in the photo). This is more difficult, but I think more reliable. Using this method, the air scoop mounted to the inside of the panel has to be removed, the grill installed and then cutting off the part of the bolt that is beyond the nut. Clearance is close. The inner scoop has to then be re-installed.

[skeet]

I've not seen any noticable increase in operating temprature-------------will see what happens when summer gets here.

[ataDude]

Very nice... and original, too!

.