-
05-08-2013, 10:24 AM
#176
Originally Posted by spyder-mumba
First of all thank you for all the great information.
I unfortunately have to make my first ride on my Spyder RRS SE5 from the dealer which is a 2.5 hour ride
Do you have any suggestions for the ride. I have ridden a Spyder before but for a very limited ride. I also used to ride a sport bike, not that they are the same.
Any insites would be appreciated
You'll know soon enough just how comfortable/apprehensive you are, or are not. That alone should be your guide as to how you approach your ride home. We're all different. My first ride was around 1700 miles home. Enjoyed every moment of it.
Take it easy and have fun.
-
05-08-2013, 06:26 PM
#177
Newbie long first ride home
Newbie here...I have read all the wonderful information you have posted and will endevour to keep up the revs and foot off the brake.
Is there anything I should be aware of with a "break-in" period. I have a 2.5 hour ride home from the dealer...is it ok to my RSS-SE5 as you have outlined even though it is right out of the crate? Any information for the ride home would be very much appreciated
-
05-08-2013, 09:32 PM
#178
Originally Posted by spyder-mumba
Newbie here...I have read all the wonderful information you have posted and will endevour to keep up the revs and foot off the brake.
Is there anything I should be aware of with a "break-in" period. I have a 2.5 hour ride home from the dealer...is it ok to my RSS-SE5 as you have outlined even though it is right out of the crate? Any information for the ride home would be very much appreciated
You will find varying opinions about properly breaking-in your Spyder.
A couple posts just mentioned most of what I would tell you...
For me it would include using varying speeds (to include highway speeds).
Back roads are good. Do not use the interstate (requires too constant of speed for too long).
Shift at the higher recommended rpm's stated at the top of this thread. (Plenty of reasons to support that. Shifting at too low of rpm's could actually be harmful -- especially during break-in.)
Take your time going home and enjoy the 2.5 hour ride!!! You should do fine.
Just stay alert to road hazards (your Spyder has a low-clearance), and don't trust any other vehicles -- as they are ALL out to run into you (at least that is the mentality you need to have).
-
05-09-2013, 07:23 PM
#179
Thanks a lot for this info, I have been riding for 6 month dealers are to helpful. thank again
-
05-10-2013, 08:13 PM
#180
BUMP to keep it alive.....
-
05-11-2013, 09:15 AM
#181
First gear
Is it ok to drive below 4300 rpm in 1st gear up hill with two people on board? (gravel road)....Thanks
-
05-11-2013, 10:45 AM
#182
Originally Posted by HuckFin
Is it ok to drive below 4300 rpm in 1st gear up hill with two people on board? (gravel road)....Thanks
Not only is it OK......it's smart.
-
05-11-2013, 01:06 PM
#183
Originally Posted by HuckFin
Is it ok to drive below 4300 rpm in 1st gear up hill with two people on board? (gravel road)....Thanks
The SE clutch locks up at 3200 rpm +/- 200. That means above 3500 you should be good to go. I wouldn't cut it any closer than I had to, but anything above four grand should be perfectly safe.
-
05-11-2013, 01:26 PM
#184
Originally Posted by Jerbear
Not only is it OK......it's smart.
Alright then...WE have a steep gravel hill from our house to the main road...Was afraid of slipping the clutch (SE-5) at low rpm, 8mph...Any slower, I get tire spin. Also, does 1st gear lock-up at low rpm, more so then the higher gears? Two of us went for a ride this morning, but to be on the safe side I walked up the hill and met my wife on top.
-
05-11-2013, 01:33 PM
#185
Originally Posted by HuckFin
Alright then...WE have a steep gravel hill from our house to the main road...Was afraid of slipping the clutch (SE-5) at low rpm, 8mph...Any slower, I get tire spin. Also, does 1st gear lock-up at low rpm, more so then the higher gears? Two of us went for a ride this morning, but to be on the safe side I walked up the hill and met my wife on top.
Originally Posted by NancysToy
The SE clutch locks up at 3200 rpm +/- 200. That means above 3500 you should be good to go. I wouldn't cut it any closer than I had to, but anything above four grand should be perfectly safe.
-
05-11-2013, 01:35 PM
#186
Originally Posted by NancysToy
The SE clutch locks up at 3200 rpm +/- 200. That means above 3500 you should be good to go. I wouldn't cut it any closer than I had to, but anything above four grand should be perfectly safe.
Looks like I need to go faster than I wanted to then, but I have to take my time getting started to keep from spinning the tire. I'll figure something out.
-
05-11-2013, 04:19 PM
#187
Originally Posted by HuckFin
Looks like I need to go faster than I wanted to then, but I have to take my time getting started to keep from spinning the tire. I'll figure something out.
You were given correct information, however sometimes you have to do what you have to. Just as long as you keep it to a minimum and pay attention to your clutch wear.
However... A real Spyder enthusiast would either have the hill taken out or move!
Just joking of course...
-
05-11-2013, 08:20 PM
#188
I would not worry about RPMs. Just focus on shift speeds, then RPMs will be handled properly. Shift to 2 @ 29, to 3rd @ 39, to 4th @ 49. those shift points will keep your rpms in proper perspective for all types of riding....flat roads, curves, or hills (up or down). Do downshifting t to 4th @ 64, to 3rd @ 49, to 2nd at 39, and to first @ 29.... just memorize it and it will make riding so much more enjoyable
Last edited by diesel-dawg; 05-11-2013 at 08:26 PM.
-
05-13-2013, 07:09 PM
#189
THANK YOU ALL
Thanks to all who replied to my "Newbie"/"First Ride" post.
I had a great but cold ride home--55F, thankful that it did not rain.
I had forgotten how much I love to ride
I had a blast and have been out every day since even though the temps are still hovering around 50.
-
05-13-2013, 07:55 PM
#190
Originally Posted by spyder-mumba
Thanks to all who replied to my "Newbie"/"First Ride" post.
I had a great but cold ride home--55F, thankful that it did not rain.
I had forgotten how much I love to ride
I had a blast and have been out every day since even though the temps are still hovering around 50.
Ha! Riding kind of makes you tolerate some of the cold; but after a while... cold is COLD!
I'll be there was a few times you almost decided to forget the break-in advice and take the nearest interstate highway and just scoot on home faster!
Glad you made it home safe and with a bit of a smile on your face...
-
05-30-2013, 12:21 AM
#191
Curves?
Dos? Don'ts? Picking up my Spyder ST Limited next week and spending 6 days riding around TX, OK and NM. Am experienced on 2 wheels and 4, Absolutely NO experience on 3. So - curves? I live in the Southern Mountains of NM and we have LOTS of curves - help?
-
05-30-2013, 04:43 AM
#192
Originally Posted by JacqueTanis
Dos? Don'ts? Picking up my Spyder ST Limited next week and spending 6 days riding around TX, OK and NM. Am experienced on 2 wheels and 4, Absolutely NO experience on 3. So - curves? I live in the Southern Mountains of NM and we have LOTS of curves - he lp?
Congrats on the new ST, Good choice you will love it. On curves just lean over your mirrors if you want to take them fast. Right curve lean over right mirror. That may be a little exaggerated but it won't take you long. Good luck. Find you a big empty parking lot and run it thru the paces.
-
05-30-2013, 06:56 AM
#193
CURVES?
You said experience with 2 wheels and 4. Is that 4 wheels with a handlebar, instead of a steering wheel, as in ATV? If so you're almost home, because the Spyder handling is very similar to an ATV. As opposed to a trike, which must be more like the old original 3-wheel ATVs, which were ultimately discontinued as being too dangerous!
-
05-30-2013, 07:12 AM
#194
Re: "Do's and Do Nots" for new Spyder owners...
Originally Posted by missouriboy
You said experience with 2 wheels and 4. Is that 4 wheels with a handlebar, instead of a steering wheel, as in ATV? If so you're almost home, because the Spyder handling is very similar to an ATV. As opposed to a trike, which must be more like the old original 3-wheel ATVs, which were ultimately discontinued as being too dangerous!
Trike is NOTHING like the old 3 wheelers. Spyder was nothing like my quad. My quad drifted, slid and tracked like it was on rails.
Sent from my SCH-I605 using Tapatalk 2
-
05-31-2013, 06:53 AM
#195
Originally Posted by dave01
Trike is NOTHING like the old 3 wheelers. Spyder was nothing like my quad. My quad drifted, slid and tracked like it was on rails.
My comments were limited to CURVES. I have ridden 3-wheel ATVs, but not a trike. I have only heard comments that it's quite easy to lift a rear trike wheel in a curve. If your experience belies that, then I'll have to defer to your experience. But on the Spyder, Nanny deals swiftly with any wheel-lift.
As to Spyders vs. ATVs in curves, I'm saying the driving techniques required are very similar; that is what I believe the original poster was asking. I have many years' experience on quads, and now 5,000 miles on my Spyder, and I tell people the steering characteristics are quite similar in curves.
-
05-31-2013, 07:04 AM
#196
Re: "Do's and Do Nots" for new Spyder owners...
Originally Posted by missouriboy
My comments were limited to CURVES. I have ridden 3-wheel ATVs, but not a trike. I have only heard comments that it's quite easy to lift a rear trike wheel in a curve. If your experience belies that, then I'll have to defer to your experience. But on the Spyder, Nanny deals swiftly with any wheel-lift.
As to Spyders vs. ATVs in curves, I'm saying the driving techniques required are very similar; that is what I believe the original poster was asking. I have many years' experience on quads, and now 5,000 miles on my Spyder, and I tell people the steering characteristics are quite similar in curves.
Gotcha, I tell them its like a go cart or small sports car. The older trikes were terrible, but they have really made good changes in the newer models. To me, the nanny took away some of the fun. Tried drifting and she told me no and took away my fun. Mean Nanny.
Sent from my Xoom using Tapatalk 2
-
05-31-2013, 07:56 AM
#197
BRP needs to add a chapter to their Manual and add this post. Thanks for taking the time to inform everyone on this important stuff that will save a lot of us some heart burn. Great Post!
-
06-01-2013, 04:45 PM
#198
-
06-07-2013, 12:14 AM
#199
regarding battery panels
I have a 2013 ST Limited and it's my first Spyder so I can only suggest an idea that may or may not work....My battery panel is in my Frunk. I changed my screws to thumb screws for easy on/off. For other Spyder models, maybe changing the battery body panel screws to thumb screws would ease the pain of keeping the battery charged using a tender?
-
06-07-2013, 12:48 AM
#200
ah...(we need a light bulb smiley)
Originally Posted by Rattigan_Roger
The removal of the body panels surrounding the battery isn't really necessary to use a battery tender.
You can connect a fused pigtail to the battery.
OH! I understand now. I thought using the tender meant removing the panels each time it was used. I see that the pigtails are a onetime install so you don't have to keep removing the panels.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|