-
2013 spyder fuel
Will all 2013 spyders now require premium fuel? The GS and RS bikes ran regular with the RT being required to use premium. Now, all spyders have the same engine. Am I correct in thinking this is the situation?
-
The Rt required Premium fuel because it has a higher compression engine then the RS to get the extra torque. Now that all models are using the same engine I would guess Premium would be required for All.
-
Doru the Destroyer-Spyder Photo Investigator
Originally Posted by Tonga
The Rt required Premium fuel because it has a higher compression engine then the RS to get the extra torque.
What is the RT engine higher compression?
-
Isn't it about 12.2:1?
I think that the older GS/RS mills were maybe 10.8:1...
-
I solved the problem on what octane to use, By using what i've always used in all my bikes, trikes,
''Premium'',
Same with all my ATV, Side bys, and especially my Chainsaw's.
-
No ethanol.. regardless of octane works best.
I was under the impression that the ratio was 13:1 for all... only the mapping was different between RS and RT ( 2012 and prior ) I think... of course I have senior moments...LOL
-
-
Very Active Member
Engine specs
2018 F3 LIMITED
-
Very Active Member
2010 engine specs
2018 F3 LIMITED
-
SpyderLovers Founder
-
Very Active Member
Originally Posted by Lamonster
I would like to see the curve of the RS, I doubt many RS owners run at 8500 rpm where peak horsepower is.
I think you're right about that. I am a little rev happy and shift at 9,000 rpm once and awhile, but I think that many never see 8,500 rpm. I seem to remember once seeing a torque and horsepower chart for the RS engine. I can't find it now.
2018 F3 LIMITED
-
Originally Posted by effgjamis
No ethanol.. regardless of octane works best.
Originally Posted by effgjamis
I was under the impression that the ratio was 13:1 for all... only the mapping was different between RS and RT ( 2012 and prior ) I think... of course I have senior moments...LOL
Good luck finding fuel with no ethanol.
-
Very Active Member
different view
Peak HP is reduced but the torque is generally higher over a wider rpm range. That equals better drivability characteristics for touring.
2018 F3 LIMITED
-
Horsepower makes for Bragging rites,
Torque makes for pulling power, and thats at 6250 RPM.
-
The peak power in most vehicles is at an rpm that most people don't reach often. Take a look at your truck, car etc.
I would love if all vehicles came with a dyno chart on the window sticker instead of some peak HP and torque figures... Tells a more useful story.
If all the 2013's are 12.2:1 then they all require minimum 91. If they used direct injection then they might be able to use 89 without any noticeable loss of power, performance or mileage.
The torque curve on a RS is pretty flat... and starts fading around 8k. The RT torque climbs until about 60ftlbs at 5500 and then falls off. (remember this is at the ground whereas BRP's figures are at the shaft.)
http://www.twobros.com/Cust_Service/...-am_spyder.pdf
http://www.twobros.com/Cust_Service/...m_spyderRT.pdf
here's a mildly modified and tuned RS http://tunedbypsi.com/dyno-record.php?Can-Am-Spyder-323
The model 991 in the RT is a great engine, very versatile. I don't blame them for putting it in all 2013's. I can't say I like throttle by wire, but I'm sure I'd get used to it just like anyone else. One less cable to adjust, lube, stretch, corrode, stick, kink, break...
-
Originally Posted by boborgera
Horsepower makes for Bragging rites,
Torque makes for pulling power, and thats at 6250 RPM.
Bob,
Why don't you throw the Tri-G's numbers down here; that torque might just scare some folks into believing!
-
Originally Posted by Bob Denman
Bob,
Why don't you throw the Tri-G's numbers down here; that torque might just scare some folks into believing!
Only 100 ft- lb, But at 3250 rpm.
But with my addition of True Duals [cat less], and a stage 1 it definitely feels like its pushing a lot more .
The stock red line is 55 hundred now it's 63 hundred, And getting 39/40 mpg on the road.
I drive it like a Diesel, No matter what gear I'm in around town [except 6Th] i keep it at 25 hundred rpm.
Last edited by boborgera; 10-10-2012 at 08:14 PM.
-
-
Very Active Member
I also think that no RS ryder will be unhappy with the "new" engine - they told me here that it would need around 10% less fuel used in an RS .. so lets see how much the ST needs then ..
Outlander fairing - Fox-shock - BajaRon Swaybar - Hankook tire/ back - 165/50 Imperial tires front & longer front shocks - GIVI Topase - Shad sidecases -heated grips - new seats
-
Originally Posted by major911
[LIST=1][*]
Good luck finding fuel with no ethanol.
I found it right here in Florida at the Stuart entrance/exit I95.They actually have a sign up stating they have Ethanol free fuel.Its the Marathon.I filled up with it Saturday.
First time I have ever seen it.
Ivor
-
Please let us know how you (or your vehicles) like it!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|