-
Very Active Member
I have a 3 arm puller that expands outward and it treads onto my 5# slide hammer. By tightening the puller as tight as I can between the hub and race edge with a few good hits with the slide hammer I was able to move the race enough to get the puller arms behind the race. From there its just a matter of working the slide hammer to finish pulling the race out.
You might scratch the hub, but the new race will cover those, and will not effect the bearings.
2021 Sea To Sky, 2020 RTL
Isn't it weird that in AMERICA our flag and our culture offend so many people......
but our benefits don't?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|