Finally broke down and decided to just order a rack for the RT trunk. Got it from Show Chrome. Now I sure hope it gets here in time to have it for the ride to Spyderfest. WooHoo...
Finally broke down and decided to just order a rack for the RT trunk. Got it from Show Chrome. Now I sure hope it gets here in time to have it for the ride to Spyderfest. WooHoo...
It's a good rack, but be aware of two things.
1. If you plan to add a high tail light, you will need the post extensions.
2. The balance cylinder for the trunk lid may not be strong enough to hold the lid up with the rack mounted, even if nothing is on the rack. Bob Finless has a video on Youtube about a cheap fix for this.
Enjoy your trip.
Last edited by Grandpot; 04-17-2016 at 04:11 PM.
2011 RTS (Sold to a very nice lady)
1998 Honda Valkyrie
2006 Mustang GT. Varooooom!
US Navy Veteran
SC Law Enforcement Boat Captain
CNC Machine Service Technician
President: Rolling Thunder SC1
Member: Disabled American Veterans, Rock Hill, SC
Member: American Legion
Experience is recognizing the same mistake every time you make it!
If your shock is weak it won't hold it up, but I new shock will hold up the new luggage rack. I like my Show Chrome rack. I just replaced my shock. Bruce
If your shock is weak it won't hold it up, but I new shock will hold up the new luggage rack. I like my Show Chrome rack. I just replaced my shock. Bruce
I just installed a second shock so problem solved X2
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
Finally broke down and decided to just order a rack for the RT trunk. Got it from Show Chrome. Now I sure hope it gets here in time to have it for the ride to Spyderfest. WooHoo...
Just tried to install one for a friend. Had to send it back because it would have warped the trunk plastic. When you receive it set the legs on a flat surface. If all 4 legs contact the surface at the same time it is good to install. The one we got had the top left leg missing the table by 3/8 of an inch and you could rock it.
Thanks for the tips everyone. I might add a second shock, but probably not the third brake light for a while. Should be the perfect spot for rain gear and the bike cover for sure.
Thanks for the tips everyone. I might add a second shock, but probably not the third brake light for a while. Should be the perfect spot for rain gear and the bike cover for sure.
This has been discussed before ( and flamed ) remember there is a weight limit.....it could be totally BOGUS but do you want to find out it's true ?????.............enjoy....Mike
I have the same Show Chrome Rack. Take your time with the mounting. cover the mounting area with painters tape,set the trunk how you want it. Then take it off and do it couple of more times. Make sure that is where you want it then make your final marks and then drill your holes. I drilled a very small pilot hole then the main hole. If you take your time with the measuring and placement prep the actual mounting is pretty easy. I put the Star washers from Value accessories under the top posts. Because of the angle the posts are at the bottom I could only use the rubber washers that came with the rack.
Happy TRAils/NSD
Paul
2012 RT L
AMA 25 years Life Member
TRA
PGR
Rhino Riders Plate #83
Venturers #78
TOI
[QUOTE=kml354;1117859]I just installed the Rivco Black rack. Love the way it doesn't block the high mount lights.
The level rack doesn't have any effect on the trunk staying open. http://rivcoproducts.com/shop-by-mot...-rt-black.html
Does the rack interfere with putting on the travel cover?
Does the rack interfere with putting on the travel cover?
The BRP half cover will no longer slip over easily. I can still use mine with the Show Chrome rack (which I love), but it is an extremely tight fit and does not cover in the same way. Others have said the Ultra Guard full cover will fit over the rack.
To the OP:
Pegasus has the best advice for you. I followed exactly what he posted here when I installed mine. Measure, measure, measure... The pilot holes and a step drill bit are an absolute must-do. I didn't use the leg extenders and the rack does clear (barely) the top edge of the trunk lid. Clearance depends on where you line up the top legs. I assembled the rack and did several test fits before deciding on final placement. Lay down some painters tape before you do anything or you will scratch the paint. Don't over-tighten the screws or you may crack the paint. Tighten per the instructions. Plan to spend an hour to install. At least 45-50 minutes will be spent measuring and tinkering with placement, lol.
There will be a few nay-sayers in the forum regarding the weight limit. Not only does the rack look great, it is very practical. I typically have a waterproof duffle bag with light clothing that weighs in under the rack limit. I have also strapped a couple of light camping chairs to the rack for Friday night concerts in the park, no problem. If you are careful and heed the trunk AND rack limits you will have miles of enjoyment. Remember, whatever you add on the rack will be part of the trunk limit.
I think the rack really adds a nice touch to an already incredible touring machine. Enjoy and safe travels to Spyderfest!
I have the BRP half cover (covers the front down to the point of the frunk and the back end is supposed to cover the trunk). Does not fit with a luggage rack on the trunk lid. I had a cause to use the cover this past weekend and what I had to do what have the front of the cover anchored up front near the ignition and then I was able to have it cover the seat and the trunk.
This has been discussed before ( and flamed ) remember there is a weight limit.....it could be totally BOGUS but do you want to find out it's true ?????.............enjoy....Mike
Yeah, I remember you got your hairs singed a while back. I'm only planning on putting light bulky stuff on the rack, like my cover, and our rain gear..3-4 lbs altogether maybe. It ain't like the neighbor kid will be riding up there...LOL
I ordered my rack over weekend and was so happy to see this discussion. I am so happy to be a part of this group. I may not post often but I read it all the time for advise. I think it covers every question I have about my spyder. I started reading this forum before I even purchased my spyder. Thanks for all the advise.
Will be getting the adjustable handlebars next service time. Of course I have read all the post on that.
I have the Show Chrome rack and the Large Iron Rider bag on my RTL and the UltraGuard 1/2 cover fits great, no problem at all. On the 1/2 cover I removed the hooks and replaced them with Velcro so in case a hook comes free in the wind it will not damage my Spyder.
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
Now I'm starting to wonder if I'll even get the rack in time for Spyderfest. I ordered through Amazon and havent gotten a "Item has shipped" email yet. I ordered it 3 days ago. Not impressed!! I emailed the seller to see if they have a status for me. I'm an idiot, I should have ordered direct!
EDIT::::Got sick of wondering. Just placed an order for the same rack through Dennis Kirk. It ships tonight, should have it Friday to install Saturday. OK, now I'm feelin' a bit better