|
-
Is this the problem? The red arrow shows what is on the outside of the panel and the yellow shows what is on the inside of the panel. That is why there is a cutout there. You loosen the lower allen screw and tuck the front piece under the panel and behind the screw and tighten it up. If the shield that the red arrow is pointing to is under the lower bike panel it will push against the brake rod, not allowing it to release. The first pic shows the shield with the red arrow on the inside. The third pic shows the shield on the outside. See the space between the rod?
rod2.jpgbike shield.jpgrod1.jpg
Last edited by stevedfive; 06-06-2013 at 11:03 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Reply With Quote