I just picked up Another 2018 RT!

[Snoking1127]

I put together another flashing third brake light for Hookie.
LEDEquiped did not have the 4 LED with the 6th cruise wire like Hooker and the SxS are using, so I found this 3 LED on Amazon and it was much cheaper.

LED https://www.amazon.com/dp/B06X9VMLQY...t_details&th=1

Timer https://www.amazon.com/dp/B07BT25J52...roduct_details

The LED has 22 or so flash patterns that are selectable. The timer lets the LED Flash(I have mine set and around 6 seconds) and then goes steady on when you apply the brakes.

The white (mine are a little off white) wire at the rear taillights is the brake light 12V and the black wire is the ground wire. I tapped into the right-side brake light, removing 1/4" of insulation and wrapping the new leads around the OEM wire, soldering the connection and then rubberized tape. I could not find my bag full on mini mon switches for the program switch, however I have the yellow (program) and red (power) leads ready for that when a new bag of switches shows up from Amazon.

The timer board is on plastic standoffs mounted through the rear wall of the top case. The program switch will through the rear wall so the push button is in the top case under the rear ledge and out of harms way.

Oh and the LED light is just held in place with 3M double back automotive trim tape. Note: The LED white wire is not used, that is from syncing multiple LED lights.

I would also note that the cable adjustments for the side cases and top case latches are in the same area.