OK Folks-

We have gotten the M2 front shocks resolved . Marcus has worked with me the entire time and resolved the height issue. Thank you Marcus!

I spoke to Marcus several times and also noted with the added length it was a bear to put in , I could not see getting it done without some creative thinking and the way the shock was very well designed to make adjustments


Now I have a 2014 RT Limited. OEM shock was around 20 inches First set I think was 18.5 inches? They went in with no problem, The new revised set was 20.5 I believe. I could not get them in the Yolks. Length issue.


Contacted Marcus and in the short time I loosen the spring tension all the way. Added a Wire tie loop to the top and bottom of the shock. Then another along the length around the two wires ties I put at the top and bottom of the shock. Compressed the shock and tightened the wire tie around the length which help keep the shock compressed during the installation process. Installed the shock, cut off the wire ties, tightened the hardware and adjusted spring tension.
Believe Marcus has come up with another idea to make them universal and will leave that up to him for the details if it happens.

Measured to make sure the spring heights were the same and ground clearance was acceptable.

Went to a quick ride around the block and all I could say was WOW. Huge difference over OEM shocks. It rode like a rail around turns, bumps were handle well and felt very planted to the ground. Now keep in mind this was only a 5 minute ride.

More to come once I get the rear shock installed.

Of course it rained most of the afternoon so I could not get more ride time in.

Here is a video from the instructions that was sent with the M2 shocks.

https://www.youtube.com/watch?v=Apqm...ature=youtu.be

If anyone has considered the M2 shocks please contact Marcus. He will take care of your needs. Customer service is OUTSTANDING

And if you buy the shocks you get two free T-Shirts too

I also want to add the quality of these shocks are outstanding too!!