-
Registered Users
Quick Release Windshield Mod
With such a wide variety of windshields to chose from and many of us who now own more than one shield, how about someone coming up with a quick release mod?
Some of you have found out the hard way that repeatedly screwing in and out the stock mounting screws will eventually strip out. If a permanent mounting plate could be made with the bolts facing out and a small knob/nut fastener to tighten, we could very quickly swap out shields.
Should be easy for someone to design and fabricate.
-
Motorbike Professor
Originally Posted by Rando
With such a wide variety of windshields to chose from and many of us who now own more than one shield, how about someone coming up with a quick release mod?
Some of you have found out the hard way that repeatedly screwing in and out the stock mounting screws will eventually strip out. If a permanent mounting plate could be made with the bolts facing out and a small knob/nut fastener to tighten, we could very quickly swap out shields.
Should be easy for someone to design and fabricate.
It will be tricky, due to the angle that the screws mount into the console and the curvature of the Spyder windshield. You'd have to have long slots in the windshield to slip over studs. I think you might be better off with a metal monting plate like the CHAD, with closer spaced fasteners for the windshield itself. You could probably fabricate some quick mounts then, but might not need to, since a steel plate with (welded nuts) wouldn't strip as readily.
-Scotty
-
Very Active Member
Originally Posted by Rando
With such a wide variety of windshields to chose from and many of us who now own more than one shield, how about someone coming up with a quick release mod?
Some of you have found out the hard way that repeatedly screwing in and out the stock mounting screws will eventually strip out. If a permanent mounting plate could be made with the bolts facing out and a small knob/nut fastener to tighten, we could very quickly swap out shields.
Should be easy for someone to design and fabricate.
I've thought about this too. Someone on one of these sites made a set of black metal that fit on each side of the shield that looked really nice - they just used longer screws that went through the plate and then the shield.
I thought of taking it a step further and making that design into a quick release system. Instead of needing to go over the screws that would stick out - you could cut the shields holes straight out to the edge so it can slip down between the console and the metal pieces and then clamp it down.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|