For a 2016 RT Limited, anyone have experience with windscreens different then the OEM ?? I am 5'10" wear a full face Shoei helmet... I constantly get a lot of wind noise and buffeting...raising the windshield does not help the problem, so I assume it is coming from the sides...
Anyone who has had a similar experience and any recommendations will be appreciated.
A vent in the shield will make a world of difference. Least expensive is to get a Goldwing vent for about $50 and cut the hole your self. Or spend $200 to $400 for an aftermarket shield ( with a vent of course ). Many here have done the replacement.
Kaos
Kaos----- Gone but not forgotten.
2014 RTS in Circuit Yellow, farkle-ing addiction down to once every few months. ECU FLASH IS GREAT.
Do you ride with your faceshield fully closed? Fully open? Somewhere in-between"
Sometimes, a small movement in the positioning of the shield can make a big difference in how the airflow plays with your head.
This past spring, I decided it would be nice to tint the short shield. I tried the film, and it didn't work, so I purchased the spray on tint. It worked, but ran. I had to apply coat after coat to get it to look good. The result was great, but in the up position, I could not see very close in front of me.
This past spring, I decided it would be nice to tint the short shield. I tried the film, and it didn't work, so I purchased the spray on tint. It worked, but ran. I had to apply coat after coat to get it to look good. The result was great, but in the up position, I could not see very close in front of me.
Do you ride with your faceshield fully closed? Fully open? Somewhere in-between"
Sometimes, a small movement in the positioning of the shield can make a big difference in how the airflow plays with your head.
Otherwise: put a vent in it!
I normally ride with the shield fully closed.... So a vent in the windshield will improve the situation?????
This past spring, I decided it would be nice to tint the short shield. I tried the film, and it didn't work, so I purchased the spray on tint. It worked, but ran. I had to apply coat after coat to get it to look good. The result was great, but in the up position, I could not see very close in front of me.
I normally ride with the shield fully closed.... So a vent in the windshield will improve the situation?????
It's sort of a "Hit & Miss" thing...
What it does; is change the airflow a little bit.
Try opening the shield up just a notch, and see what happens.
Putting a vent in your windshield will reduce the amount of buffeting, by smoothing out the airflow around it.
Basically; it reduces the size of the "low pressure" area, that exists right behind the screen ( and in front of you)
But raising your faceshield costs nothing, as a simple experiment!
It's sort of a "Hit & Miss" thing...
What it does; is change the airflow a little bit.
Try opening the shield up just a notch, and see what happens.
Putting a vent in your windshield will reduce the amount of buffeting, by smoothing out the airflow around it.
Basically; it reduces the size of the "low pressure" area, that exists right behind the screen ( and in front of you)
But raising your faceshield costs nothing, as a simple experiment!
Ok, thanks for the info, I will give it a try......
Is that the F4 sport wide tint/vent windshield that you have in your last picture?
[B]
2018 Intense Red F3T (See About Me under My Profile for mods) 2010 Timeless Black RT-622 Trailer
2014 Timeless Black RTS-SE6, 34,300 Miles, traded May 2019
2011 Timeless Black RTS-SE5, 15,180 Miles, traded April 2014
At full extension: do you look through it, or over the top?
At full extension I look through it. I find that really nice for riding in the rain. I can just close the vents and keep riding. My wife is only 5'-2" and I am 6'-2", so we are both able to stay pretty dry as long as we are moving.
2021 RTL , brake pedal from "Web Boards" chalk white
The one with the +4 width and vent is a F4 shield. I do not know the part number, but I purchased it as an open box item on Ebay for around $250 shipped. There was a slight blemish on the edge in one spot, but you would not notice it unless I point it out. Although I love it, if you are wanting a normal heigth shield (25.5"), but just +4 wide, I suggest the cheaper one by show chrome. They are less than 1/2 the price and work better. The reason I say better is because they come with the vent holes at the bottom like the stock shield. The F4 without the vent does not have the stock vent holes. JMHO
Last edited by blacklightning; 08-01-2016 at 09:07 PM.
2021 RTL , brake pedal from "Web Boards" chalk white
The one with the +4 width and vent is a F4 shield. I do not know the part number, but I purchased it as an open box item on Ebay for around $250 shipped. There was a slight blemish on the edge in one spot, but you would not notice it unless I point it out. Although I love it, if you are wanting a normal heigth shield (25.5"), but just +4 wide, I suggest the cheaper one by show chrome. They are less than 1/2 the price and work better. The reason I say better is because they come with the vent holes at the bottom like the stock shield. The F4 without the vent does not have the stock vent holes. JMHO
Ok, thanks for the info, I will go to their websites and check them out !!!!!
I'm rocking the Cal-sci stock height but wide and love it...very quiet when full up and enough air flow when down. I'm 6ft tall but have a 2xl shoei rf-1100 on the skull acting like a big sail lol.
Brian Kay - Kennesaw, GA
2014 RT-S SM6 Pearl White (KHAOS)
TricLED 3rd and 4th Brake Lights - TricLED Turn Signals - TricLED Side Fender Lights - Airhawk R Seat Pad - Smoothspyder Belt Tensioner - JT's Dash Mount - JT's USB and 12v Power Unit - Stebel 139dB Multi Sound Horn - Lamonster NBV Highway Pegs - BRP Adjustable Wind Deflectors - Cal-Sci Stock Extra Wide Windshield - Baja Ron Sway Bar - WrapMySpyder 1330 Triple decals - Ultimate Tallboy Seat - BRP Sat Radio - ELKA Stage 2 Front Shocks
I'm rocking the Cal-sci stock height but wide and love it...very quiet when full up and enough air flow when down. I'm 6ft tall but have a 2xl shoei rf-1100 on the skull acting like a big sail lol.
got a pic and price on it ?--irv
2015 rts-white pearl- mods- '16 F3 fat 6 chrome wheels,
and some little stuff. setback utopia backrest, baja ron
sway bar, oem adj. air deflectors, marlin gps compass,
lamonster fbb foot pegs[modified brackets], lamonts
vibration damper, rock guard, and side case stiffener kit,
. brp comfort seat. , fomozas and
altimax, magic mirror mts, and wide mirrors.
[joyce & irvin toms]
Love my F4 Customs stock height windshield with the Honda vent. It's a bit thicker than the OEM, crystal clear, and scratch resistant. And it covers up the bottom holes where dirt used to get in between the windshield and the bracket. You can also order it in other heights, widths, and tints.
While the stock shield worked ok, I soon got the OEM vented one. Really cut the buffeting to near zero except in truck traffic. Also 5'10" with full helmet. Love it tho couple areas tricky to clean.
While the stock shield worked ok, I soon got the OEM vented one. Really cut the buffeting to near zero except in truck traffic. Also 5'10" with full helmet. Love it tho couple areas tricky to clean.
Thanks to everyone for all the responses!!!!! Apparently the vent makes a huge difference, I am going to give it a try... Thanks again to all, love this forum, lots of info........
F4 Customs offers a variety of shields for the RT. All of the shields are made of Poly-carbonate and not Acrylic and have the High Scratch Resistance Coating built in.
They Shed Rain, are Optically Perfect, and Clean with paper towels and any glass cleaner you want to use.
You can purchase them with a 5 position adjustable vent or without however we suggest the vent as this cuts down on the back pressure and gives the rider air when required
All shields come in Clear or Tint and have a 4 year warranty.
We sell a 22", 25" (which is stock height) and a 28". All can be purchased 5" wider than stock which is great for moving the air out and around the rider and co rider.
We would love to earn your business.
Give us a call or check us out at www.f4customs.com
Don Frank
330-968-4644SRT.jpg
F4 Customs, Inc.
"The Motorcycle Windshield Folks"
941-347-7496 sales@f4customs.com
<a href='http://www.spyderlovers.com/adserver/www/delivery/ck.php?zoneid=22' target='_blank'><img src='http://www.spyderlovers.com/adserver/www/delivery/avw.php?zoneid=22&cb=567846784' border='0' alt='' /></a>
Don,
thanks for the post....
yesterday morning I sent you an email asking for info and your opinion. You replied, gave me your phone number.. I will try to call you this morning sometime....
On Thursday morning I called F4 to order the windshield. Talked with Don's daughter, Alicia. She said she would get the order out in the afternoon, on Friday Fed Ex delivered the windshield. One day service ........ Great service, really nice people to deal with, much appreciated!!!!!!! Will do the install this morning and have a test ride....
Rode 279 miles for a day ride with the new F4 windshield. It performed as Don Frank at F4 Customs said it would !!!! The wind noise is greatly reduced and most important for me, the side buffeting is gone... Perfectly clear vision. It worked as advertised, I am a happy customer !!!!!!! My wife riding as a passenger likes it also, so all is good ...........