-
Help Check Engine Light On
Help
Spyder running ruff. Would cut out at about 4th RPM in all gears. Ran it hard for a 1/2 hour. Than its started running perfect. Than Check engine light went on still runs good, but check engine light stays. Checked oil that's full. Any ideas what I should do? Dealer is 80 miles from me.
Jim
-
Check Engine light
Originally Posted by JimboRTS
Help
Spyder running ruff. Would cut out at about 4th RPM in all gears. Ran it hard for a 1/2 hour. Than its started running perfect. Than Check engine light went on still runs good, but check engine light stays. Checked oil that's full. Any ideas what I should do? Dealer is 80 miles from me.
Jim
Forgot to put in 2012 RTS auto trans.
Jim
-
Very Active Member
Double check your oil...I had a check engine light the other day and the bike wouldn't gain any rpm's....checked oil and had to add about 1/2 cup. Finicky machines.
2021 RT Limited
-
I forget what they are actually called, but there are 2 short vacuum lines on the fuel injection system that are prone to crack. That's the first thing I would check.
-
Very Active Member
Take the key out of the bike and away from it for a few minutes, give the computer a chance to reset, then try it again.
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Very Active Member
Pull the codes that should help.
2016 F3 Limited
2019 Ryker Rally
2014 Suzuki V Strom 650
2020 CSC TT 250
-
Codes
Originally Posted by Highwayman2013
Pull the codes that should help.
How do I pull the codes
Jim
-
Codes
Originally Posted by JimboRTS
How do I pull the codes
Jim
Spyder has 4,500 miles
jm
-
With the key on push the Mode, Set and Turn Signal buttons at the same time. The screen will either go blank for no active codes or you will see codes one letter and four numbers. Write them down and report them here.
2017 F3T-SM6 Squared Away Mirror Wedgies & Alignment
2014 RTS-SM6 123,600 miles Sold 11/2017
2014 RTL-SE6 8,600 miles
2011 RTS-SM5 5,000 miles
2013 RTS-SM5 burned up with 13,200 miles in 13 weeks
2010 RTS-SM5 59,148 miles
2010 RT- 622
-
Very Active Member
Try this..
download the spyder codes app to your smartphone or computer. This app is the best and will give you a wealth of information including how to pull codes (they will not show if you turn the machine off. Flip the kill switch and leave the ignition on. All codes go to storage after the computers re set) what the codes mean and how to deal with them. The one thing that does happen quite often is you will get the check engine light and it will go away and never come back which is the good thing. If the problem was not solved it will come back and it is time to see a pro...Limp mode will limit your speed and rpm's but you did not mention that.
Gene and Ilana De Laney
Mt. Helix, California
2012 RS sm5
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
Codes
Originally Posted by SpyderAnn01
With the key on push the Mode, Set and Turn Signal buttons at the same time. The screen will either go blank for no active codes or you will see codes one letter and four numbers. Write them down and report them here.
Followed above instructions and screen went blank and did not show any codes.
Jim
-
Help
Originally Posted by JimboRTS
Help
Spyder running ruff. Would cut out at about 4th RPM in all gears. Ran it hard for a 1/2 hour. Than its started running perfect. Than Check engine light went on still runs good, but check engine light stays. Checked oil that's full. Any ideas what I should do? Dealer is 80 miles from me.
Jim
Thanks for all the help and info. Will call dealer in the morning and trailer Spyder to dealer 80 miles away. When I get it fixed I'll repost the out come and what was wrong.
Jim
-
Key
Originally Posted by Cruzr Joe
Take the key out of the bike and away from it for a few minutes, give the computer a chance to reset, then try it again.
Cruzr Joe
Took the key out and away for a hour. No change Check engine light still on
Jim
-
Very Active Member
Originally Posted by Mazo EMS2
Double check your oil...I had a check engine light the other day and the bike wouldn't gain any rpm's....checked oil and had to add about 1/2 cup. Finicky machines.
The oil level on these machines is not that fussy. What you are checking is the amount of oil in the tank. Unless that level was really low and causing low oil pressure, a 1/2 cup won't make any difference in the way it runs and/or shifts. The oil tank is a just a reservoir.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|