-
Active Member
LED Blinking on and Off??
I installed LED's from TricLED on the rear fender of my 2015 F3S SE6 where the red side marker reflectors were. I also installed Blinker Modules under the passenger seat and ran the hot wires down to the new LED Red Marker Lights so they would Blink when the turn signals were engaged.
Everything works perfectly....the rear fender markers blink when the turn indicators are engaged and they go off when I hit the brakes and they are lite when I am just riding down the road. The PROBLEM IS.....after I start the bike the Right marker light after 45 seconds to 1 minute begins to blink off and on........yet when I turn on the blinkers the right and left work.....but once the blinkers are off the RIGHT LIGHT..."ONLY" blinks off and on.....it does not Strobe it just blinks off and on. Reggy from TricLED and I have spoken and we are both at a lose.
Anyone out there with Experience have any ideal why this is happening??
-
Very Active Member
this sounds like a job for SPYDER CODES!!!!!!!!!!!!!!!!!!
All the great movements in the world began with a cup of coffee!
2018 F3-T
My mods: Can am Trailer hitch, USB and 12 volt power outlets, Gustason windshield, Bead rider seat cushion, battery harness for electric gear and battery tender, Time out trailer.
-
Very Active Member
Polarity...
One thing about LED's is they have to have the same polarity. This could be the problem but in any case it is in the wires somewhere...
Gene and Ilana De Laney
Mt. Helix, California
2012 RS sm5
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
Why don't you send Reggy an email and ask him. sales@tricled.com
2017 F3T-SM6 Squared Away Mirror Wedgies & Alignment
2014 RTS-SM6 123,600 miles Sold 11/2017
2014 RTL-SE6 8,600 miles
2011 RTS-SM5 5,000 miles
2013 RTS-SM5 burned up with 13,200 miles in 13 weeks
2010 RTS-SM5 59,148 miles
2010 RT- 622
-
Active Member
Originally Posted by SpyderAnn01
Already did.
-
Active Member
Originally Posted by Chupaca
One thing about LED's is they have to have the same polarity. This could be the problem but in any case it is in the wires somewhere...
Will be looking at all wiring today.....to make sure the resistors ground and the blinking modules ground are the same. Which I believe may not be the case.....because resistors grounds are tied together under license plate and blinking modules are grounded under passenger seat to the factory wiring harness. So, will connect jumper wire between both grounds and see if blinking stops on right side.
Last edited by Hitman5363; 06-15-2016 at 06:45 AM.
-
I've got one LED, in the middle of my right fender lights, that blinks a little bit...
I jus figure it's a "spotty" connection in there, and am willing to overlook it!
(It's not worth the effort to replace the entire marker light, over one funky little bulb...)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|