Where do most people mount their Gremlin Bells on their Spyders?

[Elembytes]

Just curious where most of you mount your Gremlin Bells? I got one gifted to me recently and want a good location to put it and was wondering where others put it and what you are using to mount it with.

Thank you!

[Chupaca]

According to the ledgend, you need to mount it at the lowest point cause the gremlins come up from the road. you need to catch them before they can attach themselves to your machine...Mine is on the lower A arm shroud key ringed through a small hole. many go for the foot peg...

[PaladinLV]

On my RT IO hung it from the steel loop at the bottom of the brake lever.

AJ

Just curious where most of you mount your Gremlin Bells? I got one gifted to me recently and want a good location to put it and was wondering where others put it and what you are using to mount it with.

Thank you!

[pegasus1300]

I have two, one on each side hung from the tie rods going into the front wheels

[clinard]

A small split key ring through the bell loop and zip tied to the sway bar.

[Bfromla]

in by the front shock & A arms. For mine


I wasn't there but I still care! POW /MIA VETS

[Commander]

I put mine under the brake pedal

[oldguyinTX]

I have two, one under each passenger footboard. Drilled a hole through one of the vanes under each of the footboards and used a large key ring to attach them.

[markyodo]

I have one hanging from the muffler, and one hanging from the trailer hitch.

[oldguyinTX]

I have one hanging from the muffler, and one hanging from the trailer hitch.

That makes me think - I need to have one on my trailer. Does it count if my wife gifts it to me?

[Bob Denman]

According to the Legend: they should be hung low on the bike...

But I opted for convenience, and went for a pair of them on the license plate bracket.

[Sonrisa]

Mounted my to the brake pedalwith a key ring. I then coated the key ring with liquid lectric to prevent the ring from rusting.

[Pampurrs]

I have four gremlin bells that people have given me, one under each floorboard and one zip tied to each A-arm. To attach under the floorboards, I popped off the rubber mats, drilled a 1/4 inch hole, and fixed an inverted eyebolt to which the bells are attached.

Pam

[bmwlarry]

Mine hangs from the parking brake support on my 15 RT

[Ex-Rocket]

I have mine mounted under the brake pedal.

[SpyderNeil]

[justcalldon]

I have mine mounted under the right floor board.


Don

[WEB-WVR]

On the A arm linkage to the front wheels.

[Deanna777]

Here is where I have mine on a 2014RTS-SE6: on grill ( left side) near the drivers floor board.


Attached with a piece of wire. Deanna

[Indiana Ken]

Never heard of this.

[Ron2andia]

Never heard of this either can someone expound on the history?

[Deanna777]

Never heard of this either can someone expound on the history?

Read post # 3 on this thread. Deanna

[WA5VHU]

Right down there, with a little tape to keep it from moving and a tie-wrap to keep it on.

[jsw469]

I installed 3rd pegs on my F3T. Bought a "T" bracket from amazon and used that to go between the 3rd peg and the frame.

[Jpquinn]

Mines on the lower A arm as close to the ground as I could get it.