2013 ST Limited Speedometer Lense Replacement

[Kornflake]

Anyone replaced their lense and know how to get speedometer cluster out to complete this?

[SpyderAnn01]

Do you know if the lens is even available as a separate item? It wouldn't surprise me if you had to replace the entire cluster. Good luck!

[Kornflake]

Do you know if the lens is even available as a separate item? It wouldn't surprise me if you had to replace the entire cluster. Good luck!

I have the lens....and have removed the dash trim...just need to know the next steps to remove cluster.

[Bfromla]

Please tell us why just the lens needs replacing? Personal preference or defect? Even better if Farkle


Sent from my iPhone using Tapatalk

[billybovine]

There are 2 plastic latches at the top that really don't hold much. Thin flat blade screwdriver to pop them up then tip out gauge cluster, top first.

[Kornflake]

There are 2 plastic latches at the top that really don't hold much. Thin flat blade screwdriver to pop them up then tip out gauge cluster, top first.

Ok thank you very much! I will go and try. I am replacing because of some hazing on the lens....it was $18 part.

[AY4B]

I had the same problem and took it in to the dealer. The warranty covered the replacement.

[SpyderAnn01]

I had the same problem and took it in to the dealer. The warranty covered the replacement.

He's probably not under factory warranty and BEST would cost him $50. I'm actually amazed that the new lens is so cheap.

[GearHd]

From what I've heard, doesn't the new lense just fog back up over time? I notice it a little on our 14 ST-L.

[AY4B]

He's probably not under factory warranty and BEST would cost him $50. I'm actually amazed that the new lens is so cheap.

At first I started to try to take mine apart and only got so far. I decided to take it in and let the pros do it. It is not an easy install.

[AY4B]

The design is not good because the water from just washing the spyder by hand drains over the top of the Speedomiter and the seal is not protected at all. I was thinking about adding another bead of silicone to whats there to keep it from happening again.

[AY4B]

Thanks for bringing this up again to remind me. Ill do it when I do my Corbin install in a couple of weeks.

[Flamewinger]

Never use a power washer to wash bike. Use a gentle shower. You'd be surprised where high pressure water can get into. When I wash the dash area I use a wash mitt and sprinkle water to rinse.


Sent from my iPhone using Tapatalk

Susie - 2013 Spyder ST-Ltd
Flame Red '04 GL1800
'97 GL1500
'95 GL1500
'89 GL1500
'83 GL1100