Needing something to do this winter as the Sypdee has been parked for 8 weeks now. I used the RustOleum Black bed liner paint and now it is setting up to dry.
www.sasspyders.com
2016 F3T
2015 Freedom Trailer
Sypderpops BumpSkid Plate
Lamonster ISP Key Cover
Lamonster F3 Bar Clamp and Power Port
Lamonster RIP floorboards and frame caps
Lamonster Chevron Highway Pegs
BajaRon Swaybar & Heim Links
F4 Custom 21" tinted windshield
BRP Cannonball Seat
BRP F3 Idler Pully
FOBO TPMS
LidLox (dual)
Garmin 660LM GPS
Cat Delete Performance Pipe
F3T Top Case
PPA Black Widow Wheels
Custom Frunk Wrap
That looks good. I was thinking about chroming mine, but it don't seem to make to much of a difference in the look since it's behind the windshield IMO. I like this idea and might do the black coat instead.
2015 RT SE6 LIMITED, Black
Tri Axis Handlebar,
Ultimate Mid Rider Seat with Fuel Door
F4 Wide Tinted Windshield, with Vent
Tric Led Mirror Signals
Stebel Nautilus Compact Twin Air Horn
For a more durable finish I had mine powder coated a "Satin Black" be sure to put screws in the front holes that have threads, let the screw stick out at least a 1/2 inch so that the powder coat gets in all areas, failure to put screws in it before painting or powder coating will result in paint messing up the threads. Also ask the powder coater to pug the 6 holes in the back where the sleeve go or you will have to use emery cloth so the sleeves will go back in.
And don't forget to replace the two rubber bumpers on the front.
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
I ended up taken the bracket to get powder coated. The paint from the can scratched to easy. So, now the results from powder coated
...................Been there done that, what I found that works as far as getting the paint to be about 3 times as hard, is after it dries to the touch......Put it in an oven @ 300 *F for 10 minutes and then turn oven off and just let it cool in there for 15-20 minutes. This works with any spray paint ( except the DIP type ) and makes it very hard......Of course DO NOT DO THIS WITH >>>>PLASTIC PARTS........Mike
Last edited by BLUEKNIGHT911; 01-22-2016 at 01:15 AM.
Of course DO NOT DO THIS WITH >>>>PLASTIC PARTS........Mike [/COLOR]
Tried once in the 80s to unwarp a record (big black plastic disk for all the kids out there) by putting it in the oven. Would have worked had I remembered that it was in the oven.
Blacked-out windshield bracket
Reply With Quote
Originally Posted by KJWEB
