|
-
Active Member
 HELP S2S Won’t shift into reverse
Won’t shift into reverse any ideas guys?
2021 Sea to Sky, 2013 RT Ltd, 2005 Bombardier Outlander ATV
-
Very Active Member
My Spyder  
-
Very Active Member
Doug
2023 RT Limited, RT 622, BUDS/BUD2 Megatech/Megatronic
”Freedom is not a loophole”
F4 Customs SWCV, Ultimate, Lidlox, Adjustable Side Vents, Leather Like Grips, SS Grills, Centramatic, Garmin XT2, BajaRon Original Sway Bar w/ Lamonster links, P238
-
Very Active Member
It's a Sea to Sky so I would assume it should be under warranty. The solution rightfully is the dealer's.
-
Ozzie Ozzie Ozzie
Could this be another 20/21 Spyder with a dickie Left Hand Control Module?? 
2013 RT Ltd Pearl White
Ryde More, Worry Less!
-
Very Active Member
It could be the left hand control module or the reverse lockout switch.
 2020 F3 Ltd
Spyderpops Bumpskid
Spyderpops Brake/Run/Turn Signal LED's
Lamonster Garage LED Fog Lights and Headlights
2013 ST-S retired 1/9/16 at 25,061 miles
2015 F3S sold at 77,565 miles.
-
My '21 RTL sometimes did this when I first got it.
My throttle will sometimes stick, so that the bike is "idling" at around 1300 RPMs. This is something that will be addressed in my first service).
If the throttle isn't truly at idle, then no matter how much I push the "R" button or the paddle, it will not shift. I now make sure that I am truly at idle.
--Exco
-
Very Active Member
You aren’t pressing both buttons at the same time are you? I found I have to press the reverse button and then the paddle.
Harrington, Australia
2021 RT Limited
Setup for Tall & Big.... 200cm/6'7", 140kg/300lbs, 37"inleg.
HeliBars Handlebars
Brake rubber removed to lower pedal for easier long leg/Size 15 EEEEW boot access.
Ikon (Aussie) shocks all round.
Russell Daylong seat 2” taller than stock (in Sunbrella for Aussie heat & water resistance)
Goodyear Duragrip 165/60 fronts (18psi) - provides extra 1/2” ground clearance.
Kenda Kanine rear.
2021 RT Limited , Brake pedal rubber removed for ease of accessing pedal with size 15 boots. Red
-
tighten up your parking brake cable just abit to take the slack out
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Reply With Quote
