-
Very Active Member
Originally Posted by ulflyer
I checked them out. The tire price was within pennies the same but shipping was about $10 more than onlinetires. But if I can't get past the vehicle info requirement I may go with them. I take it they did not require you to tell what vehicle you were putting them on?
2014 Copper RTS
Tri-Axis bars, CB, BajaRon sway bar & shock adjusters, SpyderPop's Bumpskid, NBV peg brackets, LED headlights and modulator, Wolo trumpet air horns, trailer hitch, custom trailer harness, high mount turn signals, Custom Dynamics brake light, LED turn signal lights on mirrors, LED strip light for a dash light, garage door opener, LED lights in frunk, trunk, and saddlebags, RAM mounts and cradles for tablet (for GPS) and phone (for music), and Smooth Spyder belt tensioner.
-
Active Member
Federal PSI?
Good afternoon all,
Can I assume that the cold pressures would be different from a 2 ply Kenda to a 4 ply Federal?
I would think they would be slightly squishy at 20PSI.
If so, does anyone have a recommendation for the PSI of the Federals up front?
Thank you
--
Pete
-
Very Active Member
WHERE OH WHERE
WHERE OH WHERE did this idea that Kenda and 1 other tire are the ONLY tires that will fit the SPYD3Rs....?????
i've used 3 different brands; 2 brands on my RS, and now the HANKOOKs on my F3... and i have NEVER HAD A PROBLEM in over 50,000 miles of smiles...
i find my HANKOOKs are a world apart from the OEM Kenda's and would buy them again... except they are an 80,000 mile tire, and most likely i'll have another SPYD3R before these wear out....
LOOK here;
20160411_150121.jpg 20160411_150313 (1).jpg 20160411_154943.jpg
which ever tires you decide on, let us know how you like them....
Dan P
SPYD3R
-
Very Active Member
Just put a new set
Of Hankook tires on my RT this past weekend. Haven't been able to take the bike out yet so cannot say how they perform. No fitment issues to speak of though.
-
Very Active Member
PSI
Originally Posted by donnellpj
Good afternoon all,
Can I assume that the cold pressures would be different from a 2 ply Kenda to a 4 ply Federal?
I would think they would be slightly squishy at 20PSI.
If so, does anyone have a recommendation for the PSI of the Federals up front?
Thank you
--
Pete
" 16 " lbs. ... it's a car tire with much stiffer sidewalls....... so less is better ..............Mike
-
Originally Posted by donnellpj
Good afternoon all,
Can I assume that the cold pressures would be different from a 2 ply Kenda to a 4 ply Federal?
I would think they would be slightly squishy at 20PSI.
If so, does anyone have a recommendation for the PSI of the Federals up front?
Thank you
--
Pete
start with 21PSI
-
Active Member
Originally Posted by Bob Denman
I always thought that you liked some meat underneath the front end.
You have to be more careful about changing the tire diameters (As long as the new ones can fit under the fenders).
Mis-matched tires speeds can cause error messages to pop up!
Hey Bob what is the closest size you would use for the oem 165/55/15 Thanks[emoji1063]
Sent from my iPhone using Tapatalk
-
Ozzie Ozzie Ozzie
-
Member
No problème with insurance
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|