Rear break caliper plate

[Sun-_-Dragon]

Just did tire replacement on my 09 gs se5 i took the two bolts out and removed tire when i went to put it back on i noticed a plate that i didnt remove i relise its for the break caliper but only mounting is a peg on back of swing arm and what looks to be hole to fit the shaft through is this how to remount it with shaft through the plate ?


Sent from my iPhone using Tapatalk

[gnz2250]

I just did the same thing. I didn't pull the plate off, it just kind of fell off when I was pulling off the front wheels. The axle goes thru the big hole and there is a stud on the inside of the swing arm that the slotted hole fits over.

[billybovine]

Just did tire replacement on my 09 gs se5 i took the two bolts out and removed tire when i went to put it back on i noticed a plate that i didnt remove i relise its for the break caliper but only mounting is a peg on back of swing arm and what looks to be hole to fit the shaft through is this how to remount it with shaft through the plate ?


Sent from my iPhone using Tapatalk

Yup. You're doing great keep going. You will have to fus with it a bit to get it aligned so the axle will slide through.

[Bensonoid]

Next time you pull the axle put a ziptie around the swingarm to hold it in place beforehand.

[Sun-_-Dragon]

Sweet thank you was scratching my head a bit but got it on and lined up


Sent from my iPhone using Tapatalk