fog light kit

[syclemom]

Recently bought my wife a new 2014 Rt , when purchased Iordered fog light kit , has anyone installed their own fog light kit? I am going to install when they come in ,I have torn my sixes 2010 apart many times so ont think it would be too bad as I am going to blow it apart to instal, relay and aux. Fuse box for heated gear, trailer braks and trailer light isolator all at the same time.

[ARtraveler]

If you have already done stuff on the 2010 and lived...you should not have any issues with installing the fog light kit. Mine came with...but I am not mechanical, and a bit lazy too.

[Bob Denman]

BRP's instructions are pretty complete, and easy to understand; you'll have NO problem at all!

[syclemom]

Thx. I prefer to do all my own service on sixes spyder and my Bmw rt , didn't think was worth $250 to nstall when I am going to take it all apart anyway

[Chupaca]

if you have been in your previous RT you will be fine with this one...good idea to get a shop manual for it. They help a lot when doing your own work...

[Magdave]

Getting the frunk off is the hardest part. A good pair of hemostats might help if you drop the plug that is under the switch blank inside like I did. Took my wife an I ~3hrs start to finish. She provided mostly moral support but and extra pair of hands can help a little.

[syclemom]

Thx . Can get frunk off ok rest should be not too bad

[Magdave]

When you pop the switch blank off use a tack puller screwdriver and be gentle the plug for the switch does not come out too far with it. Maybe 1 inch so grab the plug before it pops off. See above