-
Active Member
12volt accessory location
Needed to install a 12 Accessory (Cig lighter) for a heated vest. Took quite awhile but I finally found the factory wiring for the frunk. If you remove the left side panel by the engine and them the left side panel on the side of the frunk, you can access the wires. I did not want the power supply in the frunk. There is no need to remove the frunk.
ImageUploadedByTapatalk1422575298.317430.jpg
This pic shows the factory supplied wires and rubber hood for the frunk mounted cig lighter (just to the left of the top of the spring). This is after I dug them out with a pair of needle nose plyers.
ImageUploadedByTapatalk1422575317.815625.jpg
The left side of the pic shows a screwdriver. The tip of the driver is positioned where the wires are zip tied to the frame. It is about four inches back but can be reached.
For reference, the left of the pics is the front of the Spyder.
Sent from my iPhone using Tapatalk
Last edited by Craniac; 01-29-2015 at 06:58 PM.
-
I just connected my vest wires to the jump terminals. Built-in fuse protects things and heat controller keeps vest & gloves at the right temp.
-
Active Member
I didn't want to have to run mine from the Frunk.
-
The Jump terminals are under the left pop-up cover under the frunk lid. They used to be under the seats in earlier models but for the newer models its easier.
ae0945c6-05b8-4d17-add5-90b72518cd18_zpsf4c1825a.jpg
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|