|
-
 Added LED turn signals
Decided to bite the bullet and add LED turn signals to the Fat White Chick. I liked Finless Bob's concept that the best place to put LEDs is on the inside edge of the mirror, allowing drivers in my blind spot to see them easily, and allowing me to see them as well.
Taking the mirrors off the body was no big deal (thank you forum) but taking the plastic bits apart, to allow me to run the wires without drilling holes, was a real pain. The plastic tabs, for the most part, are blind, so only gentle prying with a screwdriver will eventually release them. I did break one tab on the lower part of the right mirror, but it snapped back together firmly, so I am not going to worry about it.
-
Video is marked private  .
-
video
-
Very Active Member
 Originally Posted by tip
opened for me
Me too. Wonder how visible these are from behind, in the daylight.
-
Very Active Member
LIGHTS
-
Looks good,Y
You can't have too much light (if done right). You never know what will catch a caber' eye.
-
Very Active Member
Originally Posted by hognut
Video is marked private .
Opened for me also,
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Reply With Quote
