-
Added LED turn signals
Decided to bite the bullet and add LED turn signals to the Fat White Chick. I liked Finless Bob's concept that the best place to put LEDs is on the inside edge of the mirror, allowing drivers in my blind spot to see them easily, and allowing me to see them as well.
Taking the mirrors off the body was no big deal (thank you forum) but taking the plastic bits apart, to allow me to run the wires without drilling holes, was a real pain. The plastic tabs, for the most part, are blind, so only gentle prying with a screwdriver will eventually release them. I did break one tab on the lower part of the right mirror, but it snapped back together firmly, so I am not going to worry about it.
-
Active Member
Video is marked private .
-
video
-
Very Active Member
Originally Posted by hognut
Video is marked private .
Opened for me also,
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Very Active Member
Originally Posted by tip
opened for me
Me too. Wonder how visible these are from behind, in the daylight.
-
Very Active Member
LIGHTS
-
Looks good,Y
You can't have too much light (if done right). You never know what will catch a caber' eye.
-
Nicely done. (and a great choice of background music!)
Gene
2015 Honda Goldwing Comfort/Audio
**SOLD**2014 RT Limited, Black Currant
B
1975 Yamaha RD-125, Red
1500 miles, all stock time capsule!
-
Active Member
-
Active Member
Added these too!
I just added these last night. I started to attempt the disassemble process, but got too frustrated early on so I broke out the drill and made the holes just like the instructions read. I'm gunna fill the only exposed exterior hole (in the top corner) with silicone sealant. Once I made the decision to drill (won't adversly effect anything structurally), it only took a couple of minutes and looks great!
I really like being able to see if I'm the moron who left their signal blinking!
~'12 RT Limited, Pearl White~
BajaRon Anti-sway Bar
Squared Away Laser Alignment
Custom Dynamics HMT Brake Light, Front Fender Tips & Kit, Front Mud Flap LEDs, Amber & Red Brightsides, Tri-color Magicflex Channelz
Lidlox Grip Tip Helmet Locks
TricLED Mirror Signals, RGB Multi-color Halo Underground Effects Kit, LED Headlights
Palmer Signs Custom "Captain America" frunk graphics
Twisted Chrome Pinstripes
Overland Australian Sheepskin Seat Cover
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|