-
Warning!! Do not use the Insulation Snoopy used to wrap Gas Tank
This the resultIMG_20140705_193553.jpg
After wrapping the ST-S gas tank with the Cool-it insulation that Snoopy used it started to melt within 20min. What a mess!!!!!!!!!!!!
Last edited by Tazzel; 07-09-2014 at 12:18 PM.
-
-
yes, we got most of it off but there were some places we could not reach. It will have to burn off. Hopefully nothing will burst into flames
-
Thinks out loud
Snoopy ?
Identify what you have control over and find peace with what you don't.
-
Very Active Member
BAD DOG!!!!
What bike do you have?
2017 Chevrolet Camaro SS convertible. 2017 GMC Sierra cc diesel. 2017 Arctic cat RR 137 ES
-
Very Active Member
DEI is the only thing I would (and did) use no issues here
2013 Mag Silver SE5 RT BahaRon Sway bar & Sway bar links, Grip Puppies, Kuryakyn Helmet locks , Ultimate Seat w/Utopia Backrest, Dash power outlet, Spyderpops BumpSkid, Swagman Cup holders, Full size Brake Pedal, Seal DLX Floorboards, Freeway Blaster horns, Sylvania Super Bright fender LEDs, Scotchlite 680 Rear & Fender Reflectors, BRP Fog Light Kit, LED Mirror turn signal strips, 2014 RT grille mod. Outlaw Laser Alignment
-
Very Active Member
I've had mine on for 1500 miles and no issues.
It handles up to 2000 degs, so not sure if maybe you had it closer to something than I do?
Everyone always wants to kick the dog.
What type bike is it on?
Do you live in the desert?
Do you let it idle for 1/2 an hour?
LOL
-
Very Active Member
Interesting..!!
whatever it is it's a mess. Something is amiss if yours melted like that and Snoopy's is doing fine. Same stuff..?? Same heat range..?? Same installation..?? Could it have come loose falling onto the pipe..?? Regardless if rated to 2000* seems the manufacturer is stretching things...
Gene and Ilana De Laney
Mt. Helix, California
2012 RS sm5
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
Very Active Member
I strongly suspect not the same stuff. A picture of the package may be helpful.
2018 F3 LIMITED
-
Very Active Member
Mine is Thermo Tec Cool It, 2000 degs
Its in post number 95 here >>> http://www.spyderlovers.com/forums/s...Gas-Boil/page4
My pipes are wrapped too that go close to this shielding!
.
http://www.spyderlovers.com/forums/s...l=1#post776572
.
-
Very Active Member
Originally Posted by SNOOPY
I've had mine on for 1500 miles and no issues.
It handles up to 2000 degs, so not sure if maybe you had it closer to something than I do?
Everyone always wants to kick the dog.
What type bike is it on?
Do you live in the desert?
Do you let it idle for 1/2 an hour?
LOL
2017 Chevrolet Camaro SS convertible. 2017 GMC Sierra cc diesel. 2017 Arctic cat RR 137 ES
-
-
If anyone ever wants to know what the cost of free advice is; just try using it... Mark Twain.
Seriously though... what a mess. Something has to be different with the two situations.
I am listening...
SL #7026
VBA #652
HOG #3935417
2011 Viper-Red Spyder RT SE5 & Trailer
2017 HD Ultra Limited
Former Rides: 2014 HD Ultra Limited; '04 Kawa Nomad; '09 HD Ultra-Classic; and many Hondas through the years.
Spyder Newbies Do's & Do Not's: http://www.spyderlovers.com/forums/s...-Spyder-owners
-
That looks like dog crap!
-
Very Active Member
Originally Posted by Illinois Boy
If anyone ever wants to know what the cost of free advice is; just try using it... Mark Twain.
Seriously though... what a mess. Something has to be different with the two situations.
I am listening...
My bike is yellow, the fastest color. So basically I have much more airflow and haven't had any issue.
.
-
Very Active Member
I have the Thermo Tec starter heat blanket between the gas tank and seat on the wife's RTS. It works good, cut the heat under the seat. I used the Thermo Tec cool shield tape on the fuel tank and it didn't stick.
USAF '69-'89 E7
Thailand/Vietnam 1972
Member: Royal Order of Rat Bastards
-
Very Active Member
Originally Posted by SNOOPY
My bike is yellow, the fastest color. So basically I have much more airflow and haven't had any issue.
.
it used to be. Before RED was invented. That was a long time ago, you might not remember when it was reported on Huntly Brinkley.
Dan
2012 Viper Red Rt
upgrades:
Baja Ron's Anti-Sway
Diamond-R Arm Rests
Gloriders
High mount brake light
chrome front fender garnish
Bad Boy Horn
Chrome Deflector Rack
Chrome Scuff Nose Accent
Handlebar Grip Fringe
Gremlin Bells
-
Very Active Member
Originally Posted by bruiser
I have the Thermo Tec starter heat blanket between the gas tank and seat on the wife's RTS. It works good, cut the heat under the seat. I used the Thermo Tec cool shield tape on the fuel tank and it didn't stick.
Did you try cleaning the tank good? I think it has cosmoline on it.
-
Very Active Member
Originally Posted by Dan_Ashley
it used to be. Before RED was invented. That was a long time ago, you might not remember when it was reported on Huntly Brinkley.
Hmmm...perhaps, I've never seen a red Spyder in person.
-
it is rated at 2000F but the adhesive backing is only rated 300 F. It was put on a 2013 ST-S and yes he has the exhaust wrapped.
"Adhesive Backed Heat Barrier is made up of woven silica with a flexible aluminized finish. The highly reflective surface of the material is capable of withstanding radiant temperatures up to 2000°F. The adhesive backed side handles direct and continuous temperatures up to 300ºF."
http://www.thermotec.com/products/13...t-barrier.html
-
Very Active Member
Mines a ST-S also.
I've ridden it for 4-5 months now with it. Up to 2hours and 95 deg weather and have had no issues.
I'll have to pop off a panel and see if there are any signs of it anywhere coming apart.
-
Very Active Member
Originally Posted by Tazzel
it is rated at 2000F but the adhesive backing is only rated 300 F. It was put on a 2013 ST-S and yes he has the exhaust wrapped.
"Adhesive Backed Heat Barrier is made up of woven silica with a flexible aluminized finish. The highly reflective surface of the material is capable of withstanding radiant temperatures up to 2000°F. The adhesive backed side handles direct and continuous temperatures up to 300ºF."
http://www.thermotec.com/products/13...t-barrier.html
This is the one I used... http://www.thermotec.com/products/14...ntrol-mat.html
-
-
Originally Posted by Tazzel
yes, we got most of it off but there were some places we could not reach. It will have to burn off. Hopefully nothing will burst into flames
I notice in your profile you have a 2012 RS SE5 Spyder White.
I have a 2012 RT-S SM5.
Is there something about model year 2012 that suggests the fuel tank should be wrapped?
I see a lot of that mentioned for 2013, but not 2012's.
-
folks will often wrap the exhaust, and insulate the tank for personal comfort issues, that don't reach the level of functionality issues...
But there's always the potential of boiling fuel to arouse suspicions!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|